14
5
Set analogue channels
1 Register analogue channels
z
If you do not want to register the analogue channels (including cable
TV channels), press the “MENU” button to complete the settings.
z
To change the country setting, select a country and press the blue
button.
z
If “ACI Start” appears, start ACI. The cable channels will be
registered quickly. For details, refer to “What is “ACI” (Automatic
Channel Installation)?” (P. 34).
2 Check what was registered
To edit channels
g
“Editing analogue channels” (P. 15)
6
Finish
To the previous screen
g
Exit
g
To perform initial settings again
Take note that performing initial settings again will cause all channel
related settings and DTV menu settings to be lost. Press the “MENU”
button to display the menu, then press and hold the number button “1” for
more than 3 seconds to start initial settings. If initial setting does not start,
switch to the analogue channel and try again.
If you wish to make changes later, refer to “Service Scan” (P. 14) on the
separate manual “WATCHING DIGITAL CHANNELS” for digital channel
settings, or “Language” (P. 30) and “Auto Program” (P. 30) on this manual
for analogue channel settings.
No digital channels or “Missing or weak signal” message
appears
(blue)
Belgium
Nederland
Italia
España
France
Deutschland
United Kingdom
Country
Norge
Suomi
Sverige
Österreich
Danmark
Switzerland
Ireland
Auto Program
Auto Program
CH 21
0%
select a channel
BBC1
BBC2
ITV
CH4
CH5
_ _ _ _ _ _
_ _ _ _ _ _
AV
PR
ID
Edit
CH
01
CH
02
CH
03
CH
04
05
06
07
CH
CH
CH
21
22
23
24
25
26
1
Check the following points
z
Is the TV connected correctly to the aerial?
z
Change the direction of the indoor aerial.
z
Is there a digital channels transmission tower nearby?
g
Turn “Attenuator” to “On” (P. 30), since the radio waves are too
strong.
z
“Attenuator” attenuates the radio waves of analogue broadcast as
well as those of digital broadcast. If some noise or snow appears
when watching an analogue channel, please set “Attenuator” to
“Off” temporarily.
z
You can check the broadcast signal level of the channel you are
watching. For details, refer to “Signal Check” (P. 15) on the
separate manual “WATCHING DIGITAL CHANNELS”.
2
Set digital channels using “Factory Settings”. For details, refer to
“Factory Settings” (P. 15) on the separate manual “WATCHING
DIGITAL CHANNELS”.
If you still cannot watch digital channels after following the steps above,
there may be a problem with your aerial or its cable. Or, the signal may
be too weak.
g
Consult your retailer
N
Note
LT-42DR9BJ_003A.book Page 14 Thursday, September 11, 2008 3:03 PM
