English
- 22 -
Highlight
Yes
or
No
by using “ ” or “ ” buttons and
press
OK
button to confi rm.
If
Yes
is selected, automatic search starts.
Selecting
No
cancels automatic search.
After search is complete, you may see a “Choose
region” box on-screen. Press “ ” or “ ” buttons to
change region and press OK to confi rm.
Manual Search
In Manual Search, the number of the multiplex is entered
manually and only that multiplex is searched for the
channels. For every valid channel number, signal level
and signal quality are shown on the screen.
In both manual and auto search any existing channel
in the database is not re-stored to avoid redundant
duplicates of that channel.
First Time Installation
The user can use this item to load default settings,
which were loaded to the receiver at the factory.
To install factory settings, highlight “
First Time
Installation
” menu item and press
OK
button, then
you will be asked whether or not to delete the settings.
Selecting “
Yes
” by pressing
OK
button while the “
Yes
”
is highlighted, will delete the existing channel table.
After deleting the channel table a message asking to
start an automatic DIGITAL channel scan appears
Select YES and follow the on screen prompts as
described in initial settings on page 14.
Analogue TV Menu System
Picture Menu
Mode
For your viewing requirements, you can set the related
mode option.
Press “
” or “
” button to select
Mode
. Press “
” or “ ” button to choose from one of these options:
Natural, Cinema
and
Dynamic.
.
Contrast/Brightness/Sharpness/Colour/
Hue
Press “
” or “
” button to select the desired option.
Press “ ” or “ ” button to set the level.
Note: Hue option can only be visible when the TV receives
an NTSC signal.
Colour Temp
Press “
” or “
” button to select
Colour Temp
.
Press “ ” or “ ” to choose from one of these options:
Normal, Warm and Cool..
Note:
• For normal colours, select Normal option.
• Setting Warm option gives white colours a slight red
stress.
• Setting Cool option gives white colours a slight blue
stress.
Noise Reduction
If the broadcast signal is weak and the picture is
noisy, use
Noise Reduction
setting to reduce the
noise amount.
