49
IMPORTANT
PREPARE
USE
SETTING
TR
OUBLE?
ENGLI
S
H
What is “T-V LINK”?
“T-V LINK” allows the TV to share information easily with a connected “T-V LINK” compatible device.
By using T-V LINK:
z
You can send the channel information programmed on the TV to the “T-V LINK” compatible device, so that both
the TV and the external device have the same channel settings. When connecting a new external device,
channel information is loaded into it, allowing channel setup to be completed very quickly. For more details,
refer to the external device’s manual.
z
You can easily record the TV programme you are viewing on a “T-V LINK” compatible device by using the
“Direct Rec” feature. For more details, refer to the external device’s manual.
What is “ACI” (Automatic Channel Installation)?
Some cable companies transmit a signal called “ACI” which contains information that allows TV channels to be
registered automatically on your TV.
When an ACI signal is received, “ACI Start / ACI Skip” appears in the “Auto Program” screen.
Receivable broadcast systems
Depending on the country selected during “Auto Program”, the receivable broadcast system differs.
z
UNITED KINGDOM: Receive only PAL-I.
z
FRANCE: Can receive SECAM-L.
To receive SECAM-L in countries other than France:
1) Change the “Country” to “France” in “Auto Program”. (P. 44)
2) Press the “BACK” button to return to the menu and enter the channel using “Insert” or “Manual”. (P. 21)
PC signals that can be displayed
z
If the signal doesn’t appear, check that the
vertical frequency on the PC is set to “60Hz”.
Resolution
640 x 480 (VGA) 1024 x 768 (XGA)
Vertical frequency (Hz)
60.0
60.0
Connect DVI devices
Connect a DVI device to EXT-5 (HDMI) using DVI-HDMI conversion cable. Connect analogue sound output of the
DVI device to L and R terminals in EXT-4.
z
Set “Audio” in “HDMI Setting” to “Analogue” or “Auto”
g
z
EXT-6 input of LT-37ED91G/T, EXT-6 and EXT-7 inputs of LT-42ED91G do not support analogue sound
(EXT-4).
What is “Attenuator”?
Turn “Attenuator” to “On” when digital channels are not received because of too strong radio waves
g
z
“Attenuator” attenuates the radio waves of analogue broadcast as well as those of digital channels. If some
noise or snow appears when watching an analogue channel, please set “Attenuator” to “Off” temporarily.
Auto in “Zoom”
When “Auto” is selected in Zoom, the aspect ratio will turn to the ratio obtained from the information the TV
received.
z
The aspect ratio will turn to the ratio obtained from WSS (Wide Screen Identification Signal), video signal, or
control signal of the external devices. Without receiving the aspect information, it will be the setting in “4:3 Auto
Aspect”. (P. 40)
z
When 1080i (1125i) signal is received, it will be the setting in “1080i Auto Setting” (P. 40). (LT-42ED91G only)
z
Not available in PC mode.
Technical Information
For more information, please read the separate manual (WATCHING DIGITAL
CHANNELS).
“Technical Information” (P. 22 - 23)
LT-42ED91G_EN.book Page 49 Tuesday, April 29, 2008 9:31 AM
