1-18 (No.YA360)
SECTION 4
ADJUSTMENT
4.1
ADJUSTMENT PREPARATION
(1)
There are 2 ways of adjusting this TV : One is with the
REMOTE CONTROL UNIT and the other is the
conventional method using adjustment parts and
components.
(2)
The adjustment using the REMOTE CONTROL UNIT is
made on the basis of the initial setting values. The
setting values which adjust the screen to the optimum
condition can be different from the initial setting
values.
(3) Make sure that connection is correctly made AC to AC
power source.
(4) Turn on the power of the TV and measuring instruments for
warming up for at least 30 minutes before starting
adjustments.
(5) If the receive or input signal is not specified, use the most
appropriate signal for adjustment.
(6) Never touch the parts (such as variable resistors,
transformers and condensers) not shown in the adjustment
items of this service adjustment.
4.2
PRESET SETTING BEFORE ADJUSTMENTS
Unless otherwise specified in the adjustment items, preset the
following functions with the REMOTE CONTROL UNIT.
4.3
MEASURING INSTRUMENT AND FIXTURES
• Oscilloscope
• Signal generator (Pattern generator)
[PAL / 625i / 625p / 1125i(50Hz)]
• Remote control unit
4.4
ADJUSTMENT ITEMS
• 625i A-D OFFSET adjustment
• 1125i(50Hz) BRIGHTNESS adjustment
• 1125i(50Hz) A-D OFFSET adjustment
• SUB SCREEN A-D OFFSET adjustment
• WHITE BALANCE (HIGH LIGHT) adjustment
4.5
BASIC OPERATION OF SERVICE MODE
4.5.1 HOW TO ENTER THE SERVICE MODE
(1) Press
[INFORMATION]
key and
[MUTING]
key on the
remote control unit simultaneously to enter the SERVICE
MODE SCREEN.
(2) In the SERVICE MENU, press the
[1]
key to display
ADJUSTMENT MODE SCREEN.
NOTE:
• Before entering the SERVICE MODE, confirm that the
setting of VCR/TV/DVD switch is at the "
TV
" side. If the
switches have not been properly set, you cannot enter the
SERVICE MODE.
• When a number key other than the
[1]
key is pressed in the
SERVICE MODE SCREEN, the other relevant screen may
be displayed.
This is not used in the adjustment procedure. Press the
[MENU]
key to return to the SERVICE MODE SCREEN.
4.5.2 HOW TO EXIT THE SERVICE MODE
Press the
[MENU]
key to exit the Service mode.
Setting item
Settings position
PICTURE MODE
STANDARD
PICTURE adjustments
Centre
COLOUR TEMP.
NORMAL
DIGITAL VNR
AUTO (LOW)
Super DigiPure
AUTO
MOVIE THEATRE
AUTO
COLOUR MANAGEMENT
ON
PICTURE MANAGEMENT
ON
SOUND adjustments
Centre
BBE
OFF
3D SOUND
OFF
A.H.B
OFF
ZOOM
FULL
SERVICE MENU
SERVICE MENU
1.ADJUST
1.ADJUST
2.SELF_CHK
2.SELF_CHK
3.I2C STOP
3.I2C STOP
SERVICE MODE SCREEN
ADJUSTMENT MODE SCREEN
S001 PREPARE 0
S001 PREPARE 0
PAL50 FULL STD H
PAL50 FULL STD H
www.freeservicemanuals.info
4/19/2017
Digitized in Heiloo Netherland
