15
Operating external components with the remote control
NOTE
• Manufacturers’ codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.
7
To set the manufacturer’s code
You can operate a JVC TV without setting the manufacturer’s code.
1
Slide the remote control mode selector
to TV.
2
Press and hold
F
TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
4
Press number buttons (1-9, 0) to enter
the manufacturer’s code (2 digits).
Examples:
For a Hitachi TV:
Press
0
, then
7
.
For a Toshiba TV:
Press
2
, then
9
.
5
Release
F
TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
7
Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to
TV
.
The following buttons are available:
F
TV
:
Turns TV on and off.
TV VOL +/–
:
Adjusts the volume.
TV/VIDEO
:
Selects the input mode (either TV or
VIDEO).
C/–
:
Changes the channels.
1-10
,
0
,
+10 (100+)
: Selects the channel.
TV RETURN
:
Alternates between the previously selected
channel and the current channel.
The buttons described below are used on pages 15 and
16.
Operating the TV
TV VIDEO
TV
TV VOL
CHANNEL
VCR
VCR
TV
REC
ENTER
TV RETURN
100+
Remote control
mode selector
Number
buttons
(play button)
Manufac-
turer
Code
Manufactur-
er
Code
JVC
01
Nordmende
13, 14, 18, 26 – 28
Akai
02, 05
Okano
09
Blaupunkt
03
Orion
15
Daewoo
10, 31, 32
Panasonic
16, 17
Fenner
04, 31, 32
Philips
10
Fisher
05
Saba
13, 14, 18, 26 – 28
Grundig
06
Sanyo
05
Hitachi
07, 08
Schneider
02, 05
Inno-Hit
09
Sharp
20
Irradio
02, 05
Sony
21 – 25
Magnavox
10
Telefunken
13, 14, 18, 26 – 28
Mitsubishi
11, 33
Thomson
13, 14, 18,
26 – 28, 30
Miver
03
Toshiba
29
Nokia
12, 34
TH-SW9SW8[B].book Page 15 Friday, March 12, 2004 1:02 PM