6
1. Main casing grip
Attach the strap provided as shown in the
diagram above.
2. Zoom lever
Zoom (tele/wide) while shooting.
3. Ring
Commercially available filters (67 mm
diameter) can be attached.
4. Buckle (3 locations)
Seal the marine case.
5. Grip attachment holes
You can attach the grip provided, or
commercially available weights.
6. Still image lever
Press to take still images.
7. Video recording start/stop button
Press once to start recording a video.
Press again to stop.
8. Power button
Turns camera’s power on/off.
A
Inspect the main casing for scratches and
cracks.
Apply 2 or 3 drops of the anti-fog liquid
provided onto a lens tissue paper
(commercially available) or a clean cloth, and
wipe the inner side of the marine case front
glass.
B
Check the O-ring.
Using the pick provided, remove the O-ring
from the main case.
Check the O-ring, O-ring contact surface, and
groove in which the O-ring fits for foreign
matter, nicks, cracks, etc.
Be sure to remove any foreign matter (dirt,
sand, salt crystals, hair, lint, etc.).
¹
For details, refer to the “O-ring
Maintenance Manual”.
z
Never use the O-ring in case of nicks and
cracks.
z
If the O-ring is handled inappropriately, it can
cause water leakage .
C
Apply grease to the O-ring and re-attach.
D
Close the empty marine case (no camera
inside).
E
Submerge the marine case in water and
check that there are no water leaks.
(
A
Pg. 8)
Parts and Functions
8
7 6
Strap
1
2
4
4
3
5
Bottom view
Front glass
Preparation
Caution
B
WR-MG250_EN.book Page 6 Thursday, June 4, 2009 11:09 AM
