background image

SERVICE MANUAL

MC-R433U

DVD-RAM/R DRIVE

No. 6138

July 2003

COPYRIGHT © 2003 VICTOR COMPANY OF JAPAN, LTD.

This unit is the DVD-RAM/R drive designed specially for use with the JVC MC-8000 series CD/DVD Library.

SPECIFICATIONS 

100% recycled paper

MC-R433U

R

Interface

SCSI-2

Data transmission rate

Sustained  (when the maximum sync transfer

rate of the host adapter is set to 20 Mbytes/s)

DVD-RAM

2.77 Mbytes/s (2X)

(Ver. 2.1: Single-sided 4.7 GB or double-sided 9.4 GB)
DVD-RAM

1.38 Mbytes/s (1X)

(Ver. 1.0: Single side 2.6 GB, read only)
DVD-R

2.77 Mbytes/s (2X max.) (write)

(Ver. 2.1: Single-sided 4.7 GB or double-sided 9.4 GB)
DVD-R

8.31 Mbytes/s (6X max.) (read)

(Ver. 2.1: Single-sided 4.7 GB or double-sided 9.4 GB)
DVD-ROM

10 Mbytes/s

(Single Layer, 7X max.: CAV)
CD-ROM

1.5 Mbytes/s to 4.8 Mbytes/s

(32X max.: CAV)
CD-R

Max. 1.8 Mbytes/s (write)

(12X max.)
CD-RW

Max. 1.2 Mbytes/s (write)

(8X max.)
Burst (when the maximum sync transfer rate of

the host adapter is set to 20 Mbytes/s)

Max. 8 Mbytes/s (async transfer)
Max. 10 Mbytes/s (sync transfer)

Average access time (1/3 stroke)

DVD-R (4.7 GB for General)

: 145 ms

DVD-ROM (Single Layer)

: 130 ms

DVD-RAM (4.7 GB)

: 185 ms

DVD-RAM (2.6 GB)

: 195 ms

CD-ROM

: 130 ms

* The above values were measured using JVC's measure methods.

Buffer capacity 2 Mbytes

Additional write count (DVD-R for General, 4.7 GB)

500 times typical (when a disc and a drive are combined)
15 times typical

 (when a disc and multiple drives are com bined)

Dimensions

171 mm(W) x 47.5 mm(H) x 240 mm(D)

Weight

1.5 kg

Accessories

SCSI cable (with connector cap, 1 m length) ............... x 1
Clamp filter (with band) ................................... x 2
ROM ................................................................ x 3
Drive locking screw ......................................... x 2

Applicable discs

DVD-R  4.7 GB (Ver. 2.0 for General Use)
Recommended discs: Single-sided 4.7 GB

Matsushita Electric Corp.
Mitsubishi Kagaku Media Corp.
Hitachi Maxell Ltd.
TDK Corp.
Taiyo Yuden Co., Ltd.

Recommended discs: Double-sided 9.4 GB

Mitsubishi Kagaku Media Corp.
Hitachi Maxell Ltd.

DVD-R  3.95 GB (Ver. 1.0, Disc-at-once, read only)
DVD-ROM
DVD-RAM 

(Ver. 2.1, single-sided 4.7 GB, double-sided 9.4 GB)

Matsushita Electric Corp.
Hitachi Maxell Ltd.

DVD-RAM (Ver. 1.0, single-sided 2.6 GB, read only)
CD-ROM (Mode-1, Mode-2, etc.)
CD-R

Ricoh Company Ltd.
Mitsubishi Kagaku Media Corp.
Hitachi Maxell Ltd.
TDK Corp.
Taiyo Yuden Co., Ltd.
Mitsui Chemicals, Inc.

CD-RW

Ricoh Company Ltd.
Mitsubishi Kagaku Media Corp.

Design and specifications are subject to change without notice.

* Note 1 : It  is  recommended to write and

read the DVD-R, DVD-RAM, CD-R
and CD-RW discs using the drives
of the same model. If drives of dif-
ferent models are used in write
and read, discs of certain manu-
facturers or production lots may
not manifest the full performance.

* Note 2 : Only discs with a diameter of 120

mm are applicable.

* Note 3 : Use DVD-R, CD-R and CD-RW

discs that match the optimal writ-
ing speed. However, even if the
appropriate discs are used, an ad-
equate performance may not be
achieved depending on the disc
manufacturer or production lot
compatibility.

Summary of Contents for MC-R433U

Page 1: ... times typical when a disc and multiple drives are com bined 䡵 Dimensions 171 mm W x 47 5 mm H x 240 mm D 䡵 Weight 1 5 kg 䡵 Accessories SCSI cable with connector cap 1 m length x 1 Clamp filter with band x 2 ROM x 3 Drive locking screw x 2 䡵 Applicable discs DVD R 4 7 GB Ver 2 0 for General Use Recommended discs Single sided 4 7 GB Matsushita Electric Corp Mitsubishi Kagaku Media Corp Hitachi Maxe...

Page 2: ...e ROM from IC4 STEP 3 Insert the new ROM PLSS1721 into the IC4 䡵 Check that the IC numbers on the ROM and the PCB match 䡵 Install so that the notch on the ROM is on the top 䡵 Take care not to bend the ROM pins when inserting it into the socket STEP 4 Re install the side panel by performing the reverse procedure to that of STEP 1 A view of the inside of the CD ROM library when the side panel is rem...

Page 3: ...When taking out the disc take care not to leave fingerprints or scratches on the recording surface of the disc 䡵 Operation procedure 1 Insert a thin stick with a diameter of about 1 mm into the rectangular hole on the front of the drive and push it in to rotate the eject cam 2 CONN2 PCB Internal Structure Eject cam Push Continue pushing the stick in to rotate the eject cam until the tray comes out...

Page 4: ...d in Japan MC R433U No 6138 R VICTOR COMPANY OF JAPAN LIMITED is a registered Trademark owned by VICTOR COMPANY OF JAPAN LTD is a registered Trademark in Japan the U S A the U K and many other countries R R R ...

Reviews: