PD-42DX
1-42 (No.52088)
PAL/SECAM/
NTSC SUB
COLOUR
Remote control
unit
Signal generator
[2.V/C]
13. COLOUR
(Colour)
- PAL COLOUR -
(1) Receive a PAL colour bar signal (full field colour
bar).
(2) Select "2. V/C" from the SERVICE MENU.
(3) Adjust <13. COLOUR> (Colour) to set the red colour
of the colour bar signal to be the reddest. (See
Fig.4)
If noise is not completely deleted, adjust <13.
COLOUR> so that the red colour has the minimum
noise.
NOTE:
If you select an adjustment item <13. COLOUR>,
then the screen turns to an adjustment screen
shown in Fig.4.
(4) Press the [OK] key to save the value.
(5) Press the [INFORMATION] key twice to the normal
screen.
- SECAM COLOUR -
(6) Receive a SECAM colour bar signal (half colour
bar).
(7) Select "2. V/C" from the SERVICE MENU.
(8) Make similar adjustment of SECAM COLOUR in the
same way as for "PAL COLOUR". (See Fig.5)
- NTSC COLOUR -
(9) Input a NTSC 3.58 colour bar signal (full field colour
bar 75% white).
(10) Select "2. V/C” from the SERVICE MENU.
(11) Make similar adjustment of NTSC COLOUR in the
same way as for "PAL COLOUR". (See Fig.4)
(12) Input NTSC 4.43 colour bar signal (full field colour
bar 75% white), and then check the red colour of the
colour bar signal and confirm that there is no noise
or the minimum noise.
Fig.4
Fig.5
Item
Measuring
instrument
Test point
Adjustment part
Description
W
Y
CY
G
MG
R
B
Set the red colour of the colour bar to be the deepest.
W
Y
CY
G
MG
R
B
BL
Set the red colour of the colour bar to be the deepest.
Summary of Contents for PD-42DX
Page 47: ...PD 42DX No 52088 1 47 ...
