(No.YA295)1-15
3.1.15 REMOVING THE FRONT CONTROL PWB (Fig.3)
• Remove the STAND.
• Remove the REAR COVER.
• Remove the CENTRE COVER.
(1) Remove the 4 screws
[A]
, the 2 screws
[B]
and the 2
screws
[C]
, then remove the FRONT CONTROL PWB.
3.1.16 REMOVING THE FRONT LED PWB (Fig.3)
• Remove the STAND.
• Remove the REAR COVER.
• Remove the CENTRE COVER.
(1) Remove the 2 screws
[D]
, then the FRONT BASE.
(2) Remove the 2 screws
[E]
, then remove the FRONT LED
PWB.
3.1.17 REMOVING THE TEMP. SENSOR PWB (Fig.3)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 1 screw
[G]
, then remove the TEMP.
SENSOR PWB.
3.1.18 REMOVING THE MAIN POWER PWB (Fig.3)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 7 screws
[H]
, then remove the MAIN POWER
PWB.
3.1.19 REMOVING THE SUB POWER PWB (Fig.3)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 4 screws
[J]
, then remove the SUB POWER
PWB.
3.1.20 REMOVING THE PDP UNIT (Fig.3)
• Remove the STAND.
• Remove the REAR COVER.
• Remove the CENTRE COVER.
• Remove the CHASSIS SHIELD COVER.
• Remove the TERMINAL COVER.
• Remove the MAIN BASE, CHASSIS BASE and AUDIO PWB
BASE (with each PWB affixed on the MAIN BASE, CHASSIS
BASE and AUDIO PWB BASE).
• Remove the TEMP. SENSOR PWB.
• Remove the MAIN POWER PWB.
• Remove the SUB POWER PWB.
(1) Remove the 8 screws
[K]
and the 8 screws
[L]
, then
remove the BACK FRAME.
(2) Lift the PDP UNIT upright and remove it with enough care
not to impose shock to the PDP UNIT.
CAUTION:
• Two or more people are required to remove the PDP UNIT.
• The gas pouring port is covered with the protection material.
In operation, be careful not to damage the gas pouring port.
• Do not touch the front side (glass) of the PDP with your
fingers.
