1-14 (No.YA228)
3.1.14 REMOVING THE TEMP. SENSOR PWB (Fig.3)
• Remove the REAR COVER.
(1) Disconnect the connector [
CN00V
] from the TEMP.
SENSOR PWB.
(2) Remove the 1 screw
[a]
, then remove the TEMP. SENSOR
PWB.
3.1.15 REMOVING THE MAIN POWER UNIT (Fig.3)
• Remove the REAR COVER.
(1) Disconnect the connectors [
CN8001
], [
CN805
], [
CN806
],
[
CN8009
], [
CN9001
] from the MAIN POWER UNIT.
(2) Remove the 6 screws
[b]
, then remove the MAIN POWER
UNIT.
3.1.16 REMOVING THE SUB POWER PWB (Fig.3)
• Remove the REAR COVER.
(1) Disconnect the connectors [
CN9001
], [
CN9005
] [
CN9010
]
from the SUB POWER PWB.
(2) Remove the 4 screws
[c]
, then remove the SUB POWER
PWB and the INSULATOR.
3.1.17 REMOVING THE PDP UNIT (Fig.3)
• Remove the REAR COVER.
• Remove the CENTER COVER.
• Remove the CHASSIS SHIELD COVER.
• Remove the TERMINAL COVER.
• Remove the MAIN BASE, CHASSIS BASE and AUDIO PWB
BASE (with each PWB affixed on the MAIN BASE, CHASSIS
BASE and AUDIO PWB BASE).
• Remove the TEMP. SENSOR PWB.
• Remove the MAIN POWER PWB.
• Remove the SUB POWER PWB.
(1) Remove the 4 screws
[d]
, then remove the MAIN POWER
UNIT BASE (with each PWB affixed).
(2) Remove the 4 screws
[e]
and the 8 screws
[f]
, then remove
the BACK BRACKET.
(3) Remove the 8 screws
[g]
, then remove the BACK FLAME
SPACER.
(4) Lift the PDP UNIT upright and remove it with enough care
not to impose shock to the PDP UNIT.
CAUTION:
• Two or more people are required to remove the PDP UNIT.
• The gas pouring port is covered with the protection material.
In operation, be careful not to damage the gas pouring port.
• Do not touch the front side (glass) of the PDP with your
fingers.
Summary of Contents for PD-Z42DX4
Page 73: ...2 4 No YA228 ...
Page 115: ...PDP COLOUR TELEVISION INSTRUCTIONS PD Z42DX4 ENGLISH LCT1774 001A ...
Page 167: ...52 ENGLISH ...
Page 168: ... 2004 Victor Company of Japan Limited 1004MKH CR VP ...
