RS-WP1WT
1-9
Prior to performing the following procedure, remove
the rear panel assembly.
Remove the screw
M
attaching the remocon board
and disconnect the wire from connector CN913 on
the LCD board.
1.
Removing the remocon board
(See Fig.14)
Prior to performing the following procedures, remove
the rear panel assembly.
Disconnect the card wire from connector CN1 and
the antenna wire from TP1 on the tuner board
respectively.
Remove the four screws
N
attaching the tuner
board.
1.
2.
Removing the tuner board (See Fig.15)
Fig.14
Fig.15
Remocon board
M
LCD board
CN913
Tuner board
CN1
TP1
Antenna wire
N
N
Summary of Contents for RS-WP1WT
Page 37: ...RS WP1WT 3 2 M E M O ...
Page 57: ...RS WP1WT 2 4 ...
Page 66: ...RS WP1WT 2 13 Tuner Board Block No 04 ...
Page 68: ...RS WP1WT 2 15 ...