19
MHz
SLEEP
PROGRAM
RANDOM
REPEAT
AUTO
PRESET
DISPLAY
REVERSE MODE
MULTI CONTROL
REW
FF
TAPE
TUNER
BAND
FM MODE
C D
DOWN
UP
SET
AUX
SOUND
ACS
4
1
2
3
Presetting the desired stations (using the remote control unit)
30 stations in the FM band and 15 stations in the AM (MW/LW) band can
be preset as follows:
÷
Example: (Presetting an FM station broadcasting at 103.5 MHz to preset
button “15”)
1
Press the TUNER BAND/FM MODE button.
2
Select the FM band using the TUNER BAND/FM MODE button.
3
Tune to the required station.
4
Press preset button “+10”, then “5” for more than 2 sec.
(When “15” blinks in the preset station display, the station has been
stored.)
÷
Repeat the previous procedure for each of the other stations, using a
different preset button each time.
÷
Repeat the previous procedure for the other band.
÷
To change preset stations
Perform step
4
after tuning to the required station.
Notes:
÷
The previously stored station is erased when a new station is stored,
because the new station’s frequency replaces the previous frequency
in memory.
÷
When listening to an AM (MW/LW) broadcast, noise may be heard if
the remote control unit is used.
To prevent the preset stations from being erased because of a power
failure, etc., install memory back-up batteries in the unit (see page 6).
Preset station tuning
(Receiving the preset stations)
÷
The stations must be preset before this operation can be performed.
(Using the main unit)
1
Press the TUNER BAND button.
2
Select the band using the TUNER BAND button.
3
Each time the PRESET TUNING button is pressed, the next preset
station is selected.
(Using the remote control unit)
1
Press the TUNER BAND/FM MODE button.
2
Select the band using the TUNER BAND/FM MODE button.
3
Press the required preset station buttons (No. 1 – No. 10 and +10).
÷
The preset station number and frequency corresponding to the button
pressed are shown.
FM:
Adjust the telescopic antenna’s length, angle and
direction until optimum reception is received.
AM (MW/LW): Install the unit where suitable reception is possible (beside
a window, etc.) or change the direction of the unit.
Note:
The built-in ferrite core antenna can pick up interference from television
receivers in the neighborhood and thereby disturb AM (MW/LW) reception.
Using the antennas
AM (MW/LW)
FM
