JVC RX-7001PGD Service Manual Download

Page: 100 / 137

English

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.

MULTI JOG

TUNER

/SEA

MEMORY

AUDIO/
TV/VCR

CATV/DBS

Using Preset Tuning

Once a station is assigned to a channel number, the station can be
quickly tuned. You can preset up to 30 FM and 15 AM stations.

To store the preset stations

Before you start, remember...
• There is a time limit in doing the following steps. If the setting is

canceled before you finish, start from step 1 again.

On the front panel ONLY:

1. Tune in the station you want to preset (see

“Tuning in Stations Manually”).

• If you want to store the FM reception mode for this station,

select the FM reception mode you want. See “Selecting the
FM Reception Mode” on page 19.

2. Press TUNER (/SEA) MEMORY.

“CH-” appears and the channel number
position starts flashing on the display for about
10 seconds.

3. Turn MULTI JOG to select a

channel number while the channel
number position is flashing.

Note:

You can use the 10 keys on the remote control to select the preset
number. When using the 10 keys, be sure that they are activated
for the tuner, not for the CD and others. (See page 43.)

4. Press TUNER (/SEA) MEMORY

again while the selected channel
number is flashing on the display.

The selected channel number stops flashing.
The station is assigned to the selected channel number.

5. Repeat steps 1 to 4 until you store

all the stations you want.

To erase a stored preset station
Storing a new station on a used number erases the previously stored
one.

TUNER

/SEA

MEMORY

SOURCE SELECTOR

IMPORTANT:

When using the remote control, check to see if its
remote control mode selector is set to the correct
position:
To operate this receiver, set it to “AUDIO/TV/
VCR.”

Tuning in Stations Manually

Before you start, remember...
• Check the AM tuner interval spacing (9 kHz or 10 kHz) for your

area. (See page 17.)

On the front panel:

1. Turn SOURCE SELECTOR to

select the band (FM or AM).

The last received station of the selected band
is tuned in.

2. Press FM/AM TUNING.

3. Turn MULTI JOG until you find

the frequency you want.

• Turning it clockwise increases the

frequency.

• Turning it counterclockwise decreases the

frequency.

• When you turn MULTI JOG quickly, the

frequency keeps changing until a station is
tuned in.

From the remote control:

1. Press FM/AM to select the band.

• Each time you press the button, the band

alternates between FM and AM.

2. Press TUNING UP or TUNING

DOWN repeatedly until you find
the frequency you want.

• When you hold the button (and release it),

the frequency keeps changing until a
station is tuned in.

Note:

When a station of sufficient signal strength is tuned in, the TUNED
indicator lights up on the display.
When an FM stereo program is received, the STEREO indicator also
lights up.

TUNING

/REW

DOWN

TUNING

FF/

FM/AM

MULTI JOG

FM/AM TUNING

EN10_19.RX-7001PGD[U,US]/f

00.5.31, 10:55 AM