20
English
Using the SEA Modes
The SEA (Sound Effect Amplifier) modes give you control of the way your music sounds.
IMPORTANT:
When using the remote control, check to see if its
remote control mode selector is set to the correct
position:
To operate this receiver, set it to “AUDIO/TV/
VCR.”
Selecting Your Favorite SEA Mode
On the front panel:
Press SEA MODE repeatedly until the SEA
mode you want appears on the display.
• Each time you press the button, the SEA mode
changes as follows:
SEA ROCK:
Gives a heavy sound. Both high and low
frequencies are boosted.
SEA MUSICAL:
Enhances the mid-frequency range, which
the human voice is mostly made up of.
SEA MOVIE:
Adds breadth to sounds so you feel like
you are in a movie theater.
SEA COUNTRY:
Enhances the high-frequency range so that
instruments such the violin and banjo are
emphasized.
SEA JAZZ:
Gives a feeling of a live atmosphere.
Good for acoustic music.
SEA USERMODE:
Your original SEA adjustment (see the
right).
SEA OFF:
No SEA mode is applied (see below).
Notes:
• The SEA modes cannot be used for recording.
• When the SEA mode is turned on, the SEA indicator lights up on
the display.
• When the SEA mode is used with the DAP mode (see page 24),
sounds may be distorted. If this happens, turn off the DAP mode or
decrease the effect level of the DAP mode.
To cancel the SEA mode
Press SEA MODE repeatedly until “SEA OFF” appears. The SEA
indicator goes off from the display.
From the remote control:
1. Press SOUND.
The 10 keys are activated for sound adjustments.
2. Press SEA MODE repeatedly until
the SEA mode you want appears
on the display.
To cancel the SEA mode
Press SEA MODE repeatedly until “SEA OFF” appears in step 2
above. The SEA indicator goes off from the display.
SEA ADJUST
TUNER/
SEA MEMORY
SEA MODE
SEA COUNTRY
SEA JAZZ
SEA ROCK
SEA MUSICAL
SEA MOVIE
SEA USERMODE
SEA OFF
SOUND
SEA MODE
RETURN
10
AUDIO/
TV/VCR
CATV/DBS
Creating Your Own SEA Mode
You can adjust and store your own SEA adjustment into memory
(SEA USERMODE).
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
If you do not want to store your adjustment, but rather want to adjust
the SEA temporarily, skip step 4 below.
1. Press SEA ADJUST repeatedly
until the frequency range (100 Hz,
1 kHz or 10 kHz) you want
appears on the display.
2. Turn MULTI JOG to adjust the
SEA level of the selected frequency
range.
• Turning it clockwise increases the level.
• Turning it counterclockwise decreases the level.
3. Repeat step 1 and 2 to adjust other frequency
ranges if necessary.
4. Press (TUNER/) SEA MEMORY.
Your adjustment is stored into the SEA
USERMODE.
To recall your own SEA adjustment
Press SEA MODE repeatedly until “SEA USERMODE” appears.
To erase a stored adjustment
Storing a new adjustment into SEA USERMODE erases the
previously stored one.
MULTI JOG
EN20_29.RX-7001PGD[U,US]/f
00.5.31, 10:55 AM
20
Summary of Contents for RX-7001PGD
Page 28: ...2 1 ...
Page 47: ...RX 7001PGD 3 2 MEMO ...