22
CONTROL
DOWN
UP
CT SETTING
NORM
(Normal)
TEXT
Showing the Text Information on the
Display
When you have connected an MD recorder or CD player equipped
with TEXT COMPU LINK remote control system (see page 46),
you can show the text information, such as disc title or track title,
on the display of this receiver. To show it on the display, follow the
procedure below.
Before you start, remember....
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press SETTING repeatedly until “FL
DISP” (Display) appears on the
display.
The display changes to show the current setting.
2. Press CONTROL UP
5
/DOWN
∞
to select either the source name or
the text information to be shown
on the display.
• Each time you press the button, the display
changes to show the following:
NORM:
Source name and Surround/DSP mode appear
during play.
TEXT:
Text information appears during play.
Note:
Though you have selected “TEXT,” the source name and Surround/
DSP mode appear if a playing disc has no text information.
Basic Setting and Adjustment — Auto
Memory
Without any setting required, this receiver stores different sound
settings for each different playing source automatically whenever
you do the following:
• Turning on the power (see page 11)
• Changing the source to play (see page 11)
• Changing the source name (see page 16)
So, you do not have to change the sound settings next time you
select the same source. The stored settings for the selected source
are automatically recalled.
The following settings are automatically stored for each source:
• Front speaker output balance (see page 16)
• Subwoofer setting and its output level (see page 17)
• Input attenuator mode (see page 14)
• Midnight mode (see page 13)
• Bass boost (see page 14)
• Digital equalization adjustment (see page 15)
• Line direct (see page 14)
• Surround mode on/off (see page 30)
• Surround/DSP mode setting (see pages 31 – 38)
• DVD MULTI playback mode setting (see page 39)
• Analog/digital input mode (see page 20)
You can assign and store the volume level for each source. See
below.
Notes:
• If the source is FM or AM (MW/LW), you can assign different
settings for each band.
• You cannot assign and store different settings for each digital input
mode.
• The Surround modes and DSP modes cannot be used with DVD
MULTI playback mode at the same time.
To store the volume level
Before you start, remember....
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press SETTING repeatedly until “ONE
TOUCH” appears on the display.
The display changes to show the current setting.
2. Press CONTROL UP
5
/DOWN
∞
to turn on the One Touch
Operation.
The ONE TOUCH OPERATION indicator
lights up on the display.
• Each time you press the button, the one touch operation
function turns on (“ON”) and off (“OFF”).
To recall the volume level
With the ONE TOUCH OPERATION indicator lit, the volume level
for the currently selected source is recalled when the source is
selected.
To cancel the One Touch Operation
Select “OFF” in step 2 above so that the ONE TOUCH
OPERATION indicator goes off. (Even though the One Touch
Operation is canceled, the recalled volume remains active.)
CONTROL
DOWN
UP
ECT SETTING
EN11-27.RX-8010&8012R_f
01.3.19, 1:57 PM
22
