18
English
3. Connect the plug of the transmitter to the IR
OUT jack of the receiver and attach the
transmitter.
Horizontally: 60˚
Vertically: 60˚
Signal-emitting angle of the transmitter
Putting Batteries in the Remote Control
Before using the remote control, insert the two supplied batteries
first.
1. On the back of the remote control, remove the
battery cover.
2. Insert the batteries.
• Make sure to match the polarity: (+) to (+) and (–) to (–).
3. Replace the cover.
If the remote control cannot transmit signals or operate the receiver
correctly, replace the batteries. Use two LR6(AM3)/L40(15A) type
(alkaline) dry-cell batteries.
Notes:
• If you aim the remote control directly at the remote sensor on the
receiver, you can operate the receiver at a distance of up to 7 m
(23 feet).
• When replacing the batteries, finish changing them without delay;
otherwise, the stored signals are all erased (see pages 74 to 80).
When using the remote control in the dark
Press LIGHT.
The buttons on the remote control are backlit
while you are using the remote control.
If you do not press any button for about 5
seconds, the backlight will turn off.
CAUTIONS:
Follow these precautions to avoid leaking or cracking cells:
• Place batteries in the remote control so they match the polarity:
(+) to (+) and (–) to (–).
• Use the correct type of batteries. Batteries that look similar may
differ in voltage.
• Always replace both batteries at the same time.
• Do not expose batteries to heat or flame.
1
2
LR6(AM3)
/L40(15A)
3
30°
30°
15°
45°
Connecting the Power Cord
Before plugging the receiver into an AC outlet, make sure that all
connections have been made.
Connect one end of the power cord to the
AC IN socket on
the rear (
1
) and the other end into an AC outlet (
2
) .
Keep the power cord away from the connecting cables and the
antenna. The power cord may cause noise or screen interference.
Note:
The preset settings such as preset channels and sound adjustment
may be erased in a few days in the following cases:
– When you unplug the power cord.
– When a power failure occurs.
CAUTIONS:
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the cord.
When unplugging the cord, always grasp the plug so as not to
damage the cord.
1
2
Target component(s)
COMPU
LINK-4
(SYNCHRO)
AV
COMPU
LINK-
TEXT
COMPU
LINK
IR
OUT
IR
IN
CTRL
OUT
+12V
10mA MAX
Less than 3 m (10 f
eet)
At an angle of
approx. 60°
LIGHT
AC
IN
EN01-18_RX-DP20VBK[C]f
03.6.12, 2:11 PM
18
