62
English
Automatic Power On/Off (Standby): only possible with
the COMPU LINK-3 and COMPU LINK-4 connection
Automatic Power On:
• When you turn on the receiver by pressing
(STANDBY/
ON) on the unit, or AUDIO (ON) on the remote control with
ZONE 1/ZONE 2 (LEARN/TRANSMIT) selector set to
“ZONE 1”:
OR
When you turn on the Zone 1 sound by pressing ZONE 1 ON/
OFF while the receiver is turned on:
\
The ZONE 1 ON/OFF lamp lights up, and the source name for
Zone 1 appears on the display, and one of the connected
components will turn on automatically, depending on which
component has been previously selected as the
Zone 1 source
.
• When you turn on the receiver by pressing
AUDIO (ON) on the remote control, with ZONE 1/ZONE 2
(LEARN/TRANSMIT) selector set to “ZONE 2”:
OR
When you turn on the Zone 2 sound by pressing
ZONE 2 ON/OFF while the receiver is turned on:
\
The ZONE 2 ON/OFF lamp lights up and one of the
connected components will turn on automatically, depending
on which component has been previously selected as the
Zone
2 source
.
Automatic Power Off (Standby):
•
When you turn off the receiver by pressing
(STANDBY/
ON) on the unit,
or AUDIO
(STANDBY) on the remote
control,
the connected components will turn off (standby).
•
When you turn off the Zone 1 sound by pressing
ZONE 1 ON/OFF,
the selected
Zone 1 source
component turns
off (unless the same component is selected as the Zone 2 source).
– If the ZONE 2 ON/OFF lamp is lit, the
Zone 1 source
will stop
playing, but will not turn off.
•
When you turn off the Zone 2 source by pressing
ZONE 2 ON/OFF,
the selected
Zone 2 source
component turns
off (unless the same component is selected as the Zone 1 source).
– If the ZONE 1 ON/OFF lamp is lit, the
Zone 2 source
will stop
playing, but will not turn off.
Synchronized Recording
This operation is only possible when the receiver is ready for
Zone 1 operations.
Synchronized recording means the cassette deck (or MD recorder)
starts recording as soon as a CD begins playing.
To use synchronized recording, follow these steps:
1. Put a tape in the cassette deck (or an MD in the
MD recorder), and a disc in the CD player.
2. Press the record (
¶
) button and the pause (
8
)
button on the cassette deck (or on MD recorder)
at the same time.
This puts the cassette deck (or MD recorder) into recording
pause.
If you do not press the record (
¶
) button and pause (
8
) button at
the same time, the synchronized recording feature will not
operate.
3. Press the play (
3
) button on the CD player.
The
Zone 1 source
changes on the receiver, and as soon as play
starts, the cassette deck (or MD recorder) starts recording. When
play ends, the cassette deck (or MD recorder) enters recording
pause, and stops about 4 seconds later.
Notes:
• During synchronized recording;
– The selected Zone 1 source cannot be changed. (You can
change the Zone 2 source.)
– If the same source is selected both for Zone 1 and Zone 2,
operating the Zone 2 source will affect the recording.
• The COMPU LINK remote control system may not operate properly
during synchronized recording;
– If the power of any component is shut off.
– If the Zone 1 sound is turned off by pressing ZONE 1 ON/OFF.
In this case, you must start recording again from the beginning.
EN61-67_RX-DP20VBK[C]f
03.6.12, 2:24 PM
62
