24
Recording a Source
For analog-to-analog recording
You can record any analog source through the receiver to—
• the cassette deck (or MD recorder) connected to the TAPE/
MD OUT jacks,
• the VCRs connected to the VCR 1 OUT and VCR 2 OUT
jacks, and
• the CD recorder connected to the CDR OUT jacks
— at the same time.
For digital-to-digital recording
You can record the currently selected digital input source
through the receiver to a digital recording device connected to
the DIGITAL OUT terminal.
Notes:
• Analog-to-digital and digital-to-analog recordings are not
possible.
• No sound adjustments can affect the recording.
IMPORTANT:
While recording, do not turn off the receiver; otherwise, recording
will stop.
Basic adjustment auto memory
This receiver memorizes sound settings for each source—
• when you turn on the power,
• when you change the source, and
• when you turn on One Touch Operation (see page 38).
When you change the source, the memorized settings for the
newly selected source are automatically recalled.
The following can be stored for each source:
• Analog/digital input mode (see page 21)
• Input Attenuator mode (see page 22)
• Analog Direct (see page 23)
• Parametric Equalizer setting (see page 42)
• Midnight mode (see page 43)
• Surround/THX mode (see page 45)
• DSP mode (see page 52)
Notes:
• If the source is FM or AM (MW/LW), you can assign a different
setting for each band.
• If you want to memorize the volume level together with the
above settings, set “ONE TOUCH OPE” to “ON” (see page 38).
When changing the source name from “TV ” to
“DBS”:
1. Press TV/DBS.
2. Press and hold TV/DBS until “ASSGN.
DBS” appears on the display.
To change the source name to “TAPE” or “TV,”
repeat the same
procedure above—press and hold TAPE/MD to select “TAPE,” or
press and hold TV/DBS to select “TV” in step 2.
Note:
Without changing the source name, you can still use the connected
components. However, there may be some inconvenience:
– “TAPE” or “TV” will appear on the display when you select the MD
recorder or DBS tuner.
– You cannot use the digital input (see page 21) for the MD recorder.
– You cannot use the COMPU LINK or TEXT COMPU LINK remote
control system (see pages 55 and 56) to operate the MD recorder.
Using the Sleep Timer
Using the Sleep Timer, you can fall asleep to music and know the
receiver will turn off by itself rather than play all night.
From the remote control ONLY:
Press SLEEP repeatedly.
The SLEEP indicator lights up on the display, and the
shut-off time changes as follows (in minutes):
When the shut-off time comes
The receiver turns off automatically.
To check or change the time remaining until the shut-off time
Press SLEEP once.
The remaining time until the shut-off time appears in minutes.
• To change the shut-off time, press SLEEP repeatedly.
To cancel the Sleep Timer
Press SLEEP repeatedly until “SLEEP 0min.” appears on the
display. (The SLEEP indicator goes off.)
• Turning off the power also cancels the Sleep Timer.
TV/DBS
L
ANALOG
SPEAKERS
VOLUME
1
SUBWFR
R
dB
SLEEP
20
10
30
40
50
60
70
80
90
(Canceled)
0
L
ANALOG
SLEEP
SPEAKERS
VOLUME
1
SUBWFR
R
dB
SLEEP indicator
Ex. When the source is “VIDEO.”
EN18-24_RX-DP20VSL[B]f.pm5
03.5.21, 18:51
24
