(No.22019)1-9
3.1.8 Removing the DSP board & shield cover
(See Fig.7)
• Prior to performing the following procedure, remove the top
cover, rear panel and front panel assembly.
(1) Disconnect the connector
CN631
on the DSP board.
(2) Disconnect the connector
CN203
on the audio signal 1
board.
And cut off the tie bands fixing the harness.
(3) Removing the two plastic rivet, and disconnect the
connector
CN633
,
CN643
and
CN635
on the DSP board.
(4) Removing the screw
G
attaching the shield cover and
remove the shield cover.
Fig.7
3.1.9 Removing the audio signal 1 board
(See Fig.8)
• Prior to performing the following procedure, remove the top
cover, rear panel and DSP board.
(1) Disconnect the harness from the connector
CN202
,
CN204
,
CN234
,
CN224
,
CN207
and
CN223
on the audio
signal 1 board.
(2) Remove the plastic rivet.
(3) Disconnect the connector
CN205
,
CN221
and
CN206
on
the audio signal 1 board.
Fig.8
Shield cover
Top view
CN631
CN635
CN643
Plastic rivet
DSP board
G
CN203
CN633
Audio signal
1 board
Audio signal 1 board
CN234
Plastic rivet
CN224
CN204
CN202
CN205
CN221
CN206
CN223
CN207