11
Basic Settings
SUBWFR LFE
MUTIN
MH
Z
KH
Z
VOL
DGTL AUTO
L
C
R
LS
RS
DOLBY D
If the following symptoms occur while playing Dolby Digital or
DTS Digital Surround software with “DGTL AUTO” selected,
follow the procedure below.
• Sound does not come out at the beginning of playback.
• Noise comes out while searching or skipping chapters or tracks.
1
Press one of the source selecting buttons (DVD, TV, or CD) for
which you want to change the input mode.
2
Press INPUT ANALOG/DIGITAL (or INPUT A/D) to select the
digital input mode (DGTL AUTO).
3
Press CONTROL
3
(or
2
) to select “DGTL
D.D.” or “DGTL DTS” while “DGTL AUTO”
still remains on the display.
• Each time you press the button, the digital input mode changes
as follows:
• To play back software encoded with Dolby Digital, select
“DGTL D.D.”
• To play back software encoded with DTS Digital Surround,
select “DGTL DTS.”
Note:
When you turn off the power or select another source, “DGTL DTS”
and “DGTL D.D.” are canceled and the digital input mode is
automatically reset to “DGTL AUTO.”
The following are the analog/digital signal indicators on the display
to indicate what type of the signal comes into the receiver.
ANALOG
: Lights when the analog input is selected.
LPCM
: Lights when Linear PCM signals come in.
DOLBY D
: • Lights when Dolby Digital signals come in.
• Flashes when “DGTL D.D.” is selected for
software not encoded with Dolby Digital.
DTS
: • Lights when DTS Digital Surround signals come
in.
• Flashes when “DGTL DTS” is selected for
software not encoded with DTS Digital Surround.
Note:
When “DGTL AUTO” cannot recognize the incoming signals, no digital
signal indicators light up on the display.
DVD
TV
VCR
CD
DVD
INPUT
ANALOG/DIGITAL
INPUT ATT
DVD
TV
VCR
CD
DVD
Remote
NOT
Selecting the Analog or Digital Input Mode
When you have connected digital source components using both the
analog connection and the digital connection methods (see page 6),
you need to select the input mode correctly.
1
Press one of the source selecting buttons (DVD,
TV, or CD)* for which you want to change the
input mode.
Note:
*
Among the sources listed above, you can select the digital input
only for the sources which you have selected the digital input
terminals for. (See “Setting the Digital Input Terminals” on page
10.)
2
Press INPUT ANALOG/DIGITAL (or INPUT A/
D on the remote control) to select the analog or
digital input mode.
• Each time you press the button, the input mode alternates
between the analog input (ANALOG) and the digital input
(DGTL AUTO).
DGTL AUTO
: Select this for the digital input mode. The
receiver automatically detects the incoming
signal format. (The DGTL AUTO indicator
lights up on the display, then the digital signal
indicator for the detected signals lights up.)
ANALOG
: Select this for the analog input mode. (Initial
setting when shipped from the factory)
INPUT
ANALOG/DIGITAL
INPUT ATT
When “DGTL D.D.” or “DGTL DTS” is
selected, “AUTO” goes off.
SUBWFR LFE
MU
MH
KH
VO
DGTL AUTO
L
C
R
LS
RS
DOLBY D
CONTROL
EN08-16.RX-E100SL[J]_f
01.3.7, 2:49 PM
11
