21
Tuner Operations
Selecting the FM Reception Mode
When an FM stereo broadcast is hard to receive or noisy, you can
change the FM reception mode while receiving an FM broadcast.
• You can store the FM reception mode for each preset station.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
While listening to an FM station, press
CONTROL
∞
(or
5
) repeatedly until
“<FM MODE>”
appears on the display.
2
Press CONTROL
3
(or
2
) to select “MONO.”
• Each time you press the button, the FM reception mode
alternates between “AUTO MUTING” and “MONO.”
* “AUTO MUTING” is the initial setting.
MONO
: Select this to improve the reception (but stereo
effect will be lost).
In this mode, you will hear noise while tuning into
the stations. The AUTO MUTING indicator goes
off from the display. (The ST indicator also goes
off.)
AUTO MUTING
: Normally select this. When a program is
broadcasted in stereo, you will hear stereo sound;
when in monaural, you will hear monaural sounds.
This mode is also useful to suppress static noise
between stations. The AUTO MUTING indicator
lights up on the display.
To restore the stereo effect
Repeat step 1, then select “AUTO MUTING” in step 2.
MEMORY
Remote
NOT
CONTROL
Ex.: When selecting the FM band
FM
AM
ST
TUNED
MUTING
MH
Z
VOL
AUTO
ST
TUNED
MUTING
MH
Z
VOL
AUTO
ST
TUNED
MUTING
VOL
AUTO
Then
ST
TUNED
MUTING
MH
Z
VOL
AUTO
CONTROL
ST
TUNED
MUTING
MH
Z
VOL
AUTO
ANALOG
TUNED
MH
Z
VOL
L
R
CONTROL
4
Press MEMORY again while the selected channel
number is flashing on the display.
The selected channel number stops flashing.
The station is assigned to the selected channel number.
5
Repeat steps
1
to
4
until you store all the
stations you want.
To erase a stored preset station
Storing a new station on a used channel number erases the
previously stored one.
To tune in a preset station
1
Press FM or AM to select the band.
The last received station of the selected band is tuned in, and the
CONTROL buttons now work for tuner operations.
2
Press CONTROL
∞
(or
5
) repeatedly until
“< PRESET >” appears on the display.
3
Press CONTROL
3
or
2
to select a preset
channel number you want.
• Pressing (or holding) CONTROL
3
increases the preset
channel numbers.
• Pressing (or holding) CONTROL
2
decreases the preset
channel numbers.
When using the remote control
1
Press FM or AM.
The last received station of the selected band is tuned in, and the
10 keys now work for tuner operations.
2
Press the 10 keys to select a preset channel number.
• For channel number 5, press 5.
• For channel number 15, press +10 then 5.
• For channel number 30, press +10, +10, then 10.
Preset channel number appears.
CONTROL
ST
TUNED
MUTING
MH
Z
VOL
AUTO
EN20-21.RX-E100SL[J]_f
01.3.7, 2:51 PM
21
