RX-E100SL
1-7
Prior to performing the following procedure, remove
the top cover and the rear panel.
Disconnect the harness connected to connector
CN217 on the power / fuse board (If necessary, cut
off the band fixing the harness on the side of the
base chassis).
Unsolder the power cord and other harnesses
connected to the power / fuse board.
Remove the screw O attaching the power / fuse
board.
1.
2.
3.
Removing the power / fuse board
(See Fig.13)
Prior to performing the following procedures, remove
the top cover.
Disconnect the harness from connector CN217 on
the power / fuse board (If necessary, cut off the tie
band fixing the harness).
Disconnect the harness from connector CN201 and
CN202 on the power supply board and main board.
Remove the four screws M attaching the power
transformer.
1.
2.
3.
Removing the power transformer
(See Fig.12 and 13)
Prior to performing the following procedure, remove
the top cover.
Disconnect the card wire from connector CN204 on
the power supply board.
Disconnect the harness connected to connector
CN201 and CN707 on the power supply board
(If necessary, cut off the band fixing the harness on
the side of the base chassis).
Disconnect the harness connected to connector
CN206 on the main board
Remove the three screws N attaching the power
supply board.
Unsolder the three harnesses connected to the
power supply board.
1.
2.
3.
4.
5.
Removing the power supply board
(See Fig.12)
Fig.12
Fig.13
Power
supply
board
CN707
Power
transformer
M
Solder
M
Solder
N
Power / fuse board
Power cord
Power
transformer
board
PW201
PW203
CN204
PW202
N
N
CN201
O
CN217
Hook
CN206
CN202
Tie band
Tie band
Summary of Contents for RX-E100SL
Page 31: ...RX E100SL 3 2 M E M O ...