1-6 (No.MB127)
SECTION 3
DISASSEMBLY
3.1
Main body section
3.1.1
Removing the top cover
(See Figs.1 and 2)
(1) From the back side of the main body, remove the three
screws
A
attaching the top cover. (See Fig.1)
(2) From the both sides of the main body, remove the four
screws
B
attaching the top cover. (See Fig.1)
(3) Remove the top cover by moving up the back part of the top
cover and release the six joints
a
using a longer driver from
the inside. (See Fig.2.)
Note:
•Do not damage any part and board inside the main body when
releasing the joints
a
using a longer driver.
Fig.1
3.1.2
Removing the front panel assembly
(See Figs.2 to 4.)
• Prior to perform the following procedures, remove the top cov-
er.
(1) From the top side of the main body, cut the tie bands and
disconnect the wire from the connector
CN451
on the main
board. (See Fig.2.)
(2) From the bottom side of the main body, remove the four
screws
C
attaching the front panel assembly. (See Fig.3.)
(3) From the both sides of the main body, release the joints
b
and remove the front panel assembly in the direction of the
arrow. (See Fig.4.)
(4) From the top side of the main body, remove the screw
D
at-
taching the earth wire on the DC power board. (See Fig.2.)
References:
• After attaching the front panel assembly, bundling the wires
using the new tie bands.
• When attaching the screw
D
, attach the earth wire with it.
Fig.3
Fig.2
Fig.4
A
B
x2
B
x2
Top cover
C
Front panel assembly
CN451
Main board
Front panel assembly
Joints
a
Tie bands
Earth wire
D
DC power
board
Front panel assembly
Joint
b