42
You can use the supplied remote control to operate not only
this receiver but also other JVC products.
• Refer also to the manuals supplied with the other products.
Some JVC VCRs can accept two types of the control signals—
remote codes “A” and “B.”
– When operating a VCR whose remote control code is set to
“A,” set the manufacturer’s code to “01.”
– When operating a VCR whose remote control code is set to
“B,” set the manufacturer’s code to “02.”
The initial setting is “01.” For details about the setting, see
“Changing the transmittable signals for operating a VCR” on
page 45.
• To operate other products, aim the remote control directly at the
remote sensor on the target product.
7
TV
Operating other
JVC products
You can always perform the following operations:
TV
:
Turn on or off the TV.
TV VOL +/–:
Adjust the volume on the TV.
TV/VIDEO:
Change the input mode (either video input
or TV tuner) on the TV.
After pressing TV, you can perform the following operations on the
TV.
C/–:
Change the channel numbers.
1 – 9, 0, 100+:
Select the channel numbers.
TV RETURN (10):
Function as the TV RETURN button.
(Switches between the previous channel
and the current channel.)
Set the mode selector to
“AUDIO/TV/VCR/DBS.”
7
VCR
You can always perform the following operation:
VCR
:
Turn on or off the VCR.
After pressing VCR, you can perform the following operations on
the VCR.
C/–:
Change the channel numbers on the VCR.
1 – 9, 0:
Select the channel numbers on the VCR.
3
:
Start playback.
7
:
Stop playback.
8
:
Pause playback. To release it, press
3
.
¡
:
Fast-wind a tape.
1
:
Rewind a tape.
REC PAUSE:
Enter recording pause. To start recording,
press this button then
3
.
Set the mode selector to
“AUDIO/TV/VCR/DBS.”
7
DVD recorder or DVD player
To operate the DVD
recorder, set the mode
selector to “DVR.”
To operate the DVD player,
set the mode selector to
“DVD.”
EN42-46RXF31S[UJ]1.p65
05.4.25, 15:48
42
