1-10 (No.MB421)
3.1.3 Removing the rear panel
(See Fig.8)
• Prior to performing the following procedures, remove the metal
cover.
(1) From the back side of the main body, remove the screw
E
and nine screws
F
attaching the rear panel.
Fig.8
3.1.4 Removing the audio signal input/output board
• Prior to performing the following procedures, remove the metal
cover.
(1) From the back side of the main body, remove the screw
E
,
two screws
G
attaching the audio signal input/output board
to the rear panel. (See Fig.9)
(2) Take out the audio signal input/output board, and discon-
nect the card wires from the connectors
CN411
and
CN412
on the main board. (See Fig.10)
3.1.5 Removing the tuner assembly
• Prior to performing the following procedures, remove the metal
cover and audio signal input/output board.
(1) From the back side of the main body, remove the two
screws
H
attaching the tuner assembly to the rear panel.
(See Fig.9)
(2) From the top side of the main body, disconnect the card
wire from the connector
CN410
on the main board. (See
(3) Take out the tuner assembly from the main body.
3.1.6 Removing the DVD mechanism assembly
(See Fig.11)
• Prior to performing the following procedures, remove metal
cover and audio signal input/output board.
(1) From the top side of the main body, disconnect the card
wires from the connectors
CN401
,
CN402
and
CN408
on
the main board.
(2) Remove the screw
J
attaching the DVD mechanism as-
sembly on the main body.
Fig.9
Fig.10
Fig.11
E
F
Rear panel
E
G
H
Rear panel
CN412
CN411
Audio signal input/output board
Main board
J
CN401
CN408
CN410
Tuner assembly
CN402
DVD mechanism assembly
Main board