15
Installation and Setup
5.1 Speaker Setup
Make the following settings for the built-in 5.1 channel
surround decoder.
1. Press ENTER, and the 5.1 Speaker Setup menu
appears.
2. Use
b
/
B
to select the desired speaker.
3. Adjust options using
v
/
V
/
b
/
B
buttons.
4. Press ENTER to confirm your selection. Returns to
the previous menu.
Speaker selection
Select a speaker that you want to adjust. [Front
speaker (Front L), Front speaker (Front R), Center
Speaker (Center), Subwoofer (SubWoofer), Rear
speaker (Rear L), Rear speaker (Rear R)]
Note:
Certain speaker settings are prohibited by the Dolby
Digital licensing agreement.
Size
Since the speaker settings are fixed, you cannot
change the settings.
Volume
Press
b
/
B
to adjust the output level of the selected
speaker. (-5dB ~ 5dB)
Distance
After you connected speakers to your DVD Receiver,
set the Distance between the speakers and your
listening point if the distance of Center or Rear
speakers is bigger than the distance of Front
speakers. This allows the sound from each speaker to
reach the listener at the same time.
Press
b
/
B
to adjust the Distance of the selected
speaker. This distance is equivalent to a difference of
the distance between Center or Rear speaker and
Front speakers.
Note:
You can’t adjust Front/Woofer speakers.
The distance of Front speaker is considered to be the
standard.
Test
Press
b
/
B
to test the signals of each speaker. Adjust
the volume to match the volume of test signals
memorized in the system.
Front Left (Front L)
→
Center
→
Front Right (Front R)
→
Rear Right (Rear R)
→
Rear Left (Rear L)
→
SubWoofer
LOCK (Parental Control)
Initial Setting the Area Code:
See the Area Codes on page 26.
1. Select the LOCK menu and then press
B
.
2. To access the LOCK options, you must input the
password you have created. Input a password and
press ENTER. Enter it again and press ENTER to
verify. If you make a mistake before pressing
ENTER, press CLEAR.
3. Select the first character using
v
/
V
buttons.
4. Press
B
and select the second character using
v
/
V
buttons.
5. Press ENTER to confirm your Area code selection.
