1-12 (No.MB665<Rev.004>)
3.1.8 Removing the Micom board (See Fig.15, 16)
(1) Remove the two screws
J
attaching the Micom board. (See
Fig.15)
(2) Disconnect the flat cable wire from Micom board connected
to connector
CN201
and
CN203
of the Power board. (See
Fig.16)
(3) Disconnect the board to board connector connected to
connector
CN204
of the Power board. (See Fig.16)
(4) Disconnect the board to board connector connected to
connector
CN803
of the USB jack board. (See Fig.16)
Fig.15
Fig.16
3.1.9 Removing the USB jack board (See Fig.17)
(1) Remove the three screws
K
attaching the USB jack board.
3.1.10 Removing the Power board (See Fig.17)
(1) Disconnect the power cord connected to connector
CN200
of the Power board.
(2) Remove the four screws
L
attaching the Power board.
Fig.17
J
CN204
CN803
CN203
CN201
CN200
K
L
L
Summary of Contents for SP-UXG300
Page 37: ... M E M O ...
Page 57: ...3 19 MEMO ...
