19
Specifications
Amplifier section
OUTPUT POWER:
60 W (30 W + 30 W) at 4 Ω (10% THD)
Speakers/Impedance:
4 Ω – 16 Ω
Audio input
AUDIO IN: 500 mV/47 kΩ (at “IN LVL1”)
250 mV/47 kΩ (at “IN LVL2”)
125 mV/47 kΩ (at “IN LVL3”)
Digital input:
USB MEMORY
Tuner section
FM tuning range:
87.50 MHz – 108.00 MHz
AM tuning range:
522 kHz – 1 629 kHz
DAB tuning range:
BAND III: 174.928 MHz
– 239.200 MHz
L-BAND: 1 452.960 MHz
– 1 490.624 MHz
CD player section
Dynamic range:
88 dB
Signal-to-noise ratio:
85 dB
Wow and flutter:
Immeasurable
USB storage
USB specification:
Compatible with USB 2.0 Full
Speed
Compatible device:
Mass storage class
Compatible file system:
FAT16, FAT32
Bus power supply:
Max. 500 mA
Speakers
Speaker units:
10 cm cone x 1
Impedance:
4 Ω
Dimensions (approx.):
160 mm x 250 mm x 150 mm
(W/H/D)
Mass (approx.):
1.6 k
g
each
General
Power requirements:
AC 230 V , 50 Hz
Power supply to USB mass storage class device:
DC 5 V
500 mA
Power consumption:
25 W (power on)
6.5 W (standby mode)
1 W or less (ECO Mode)
Dimensions (approx.):
165 mm x 251 mm x 269 mm
(W/H/D)
Mass (approx.):
2.6 k
g
Specifications and appearance are subject to change
without prior notice.
JVC bears no responsibility for any loss of data in USB
mass storage class device while using this System.
Microsoft and Windows Media are either registered
trademarks or trademarks of Microsoft Corporation in
the United States and/or other countries.
Maintenance
To get the best performance of the System, keep your
discs and mechanism clean.
Handling discs
• Remove the disc from its case by holding it at the
edge while pressing the center hole lightly.
• Do not touch the shiny surface of the disc, or bend
the disc.
• Put the disc back in its case after use.
• Be careful not to scratch the surface of the disc when
placing it back in its case.
• Avoid exposure to direct sunlight, temperature
extremes, and moisture.
To clean the disc:
• Wipe the disc with a soft cloth in a straight line from
center to edge.
Cleaning the System
• Stains should be wiped off with a soft cloth. If the
System is heavily stained, wipe it with a cloth soaked
in water-diluted neutral detergent and wrung well,
then wipe clean with a dry cloth.
• Since the System may deteriorate in quality, become
damaged or get its paint peeled off, be careful about
the following:
– DO NOT wipe it hard.
– DO NOT wipe it with thinner or benzine.
– DO NOT apply any volatile substance such as
insecticides to it.
– DO NOT allow any rubber or plastic to remain in
contact for a long time.
EN13-20_UX-G800D[B]f.indd 19
EN13-20_UX-G800D[B]f.indd 19
3/11/08 2:03:39 PM
3/11/08 2:03:39 PM
