1-20 (No.MB338)
3.2.7 Removing the pickup
(See Figs.7, 9 to 11)
• Remove the DVD cover and traverse mechanism assembly.
(1) From the side of the traverse mechanism assembly, solder
the short land sections
e
of the pickup. (See Fig.7.)
(2) Release the lock of the connector of the pickup in the direc-
tion of the arrow and disconnect the card wire. (See Fig.9.)
Caution:
• Solder the short land section
e
on the pickup before
disconnecting the card wire from the connector on the
pickup. If the card wire is disconnected without attach-
ing solder, the pickup may be destroyed by static elec-
tricity. (See Figs.7 and 9.)
• When attaching the pickup, be sure to remove solders
from the short land section
e
after connecting the card
wire to the connector on the pickup. (See Figs.7 and
9.)
(3) Remove the screw
F
attaching the plate and thrust spring.
(See Fig.9.)
(4) Remove the plate from the joint
i
of the feed holder and
take out the plate with the thrust spring. (See Fig.9.)
(5) Remove the shaft of the pickup from the section
j
of the
traverse mechanism assembly and remove it from the sec-
tion
k
while moving the shaft in the direction of the arrow.
(See Fig.10.)
(6) Remove the pickup from the section
m
of the traverse
mechanism assembly and take out the pickup with the
shaft. (See Fig.10.)
(7) From the bottom side of the pickup, remove the two screws
G
attaching the SW actuator and LEAD spring. (See
Fig.11.)
(8) Pull the shaft out of the pickup. (See Fig.11.)
Fig.9
Fig.10
Fig.11
Thrust spring
Pickup
Connector
Plate
Card wire
Feed holder
F
i
Shaft
Pickup
Traverse mechanism assembly
j
k
m
Pickup
SW actuator
LEAD spring
G
Shaft
Summary of Contents for SP-UXQD9S
Page 32: ...1 32 No MB338 SECTION 5 TROUBLESHOOTING This service manual does not describe TROUBLESHOOTING ...
Page 33: ... No MB338 1 33 ...
Page 41: ...2 5 SHEET 4 ...
Page 71: ...3 21 MEMO ...
