Changing Playback Settings
Displaying the playback settings menu
1
Press the [PB MODE] button on the remote control
unit during the playback of a title
0
The Settings Menu screen appears.
0
The playback settings menu can only be displayed during
the playback of a title.
0
Only settings that are supported by the current title being
played back can be changed in the playback settings
menu.
Items displayed in gray cannot be set.
Playback Settings Menu
Audio/subtitle settings
.
#7&+157$6+6.'
#7&+1.#0)7#)'
%*#0)'#7&+1176276
.4
57$6+6.'.#0)7#)'
Memo :
0
“AUDIO/SUBTITLE” will be displayed only if they are
available in the video content. The setting value differs
depending on the content. Items that are not available in the
content cannot be set.
AUDIO LANGUAGE
CHANGE AUDIO OUTPUT
SIGNAL TYPE (BD-ROM)
0
PRIMARY VIDEO
0
PRIMARY AUDIO
0
SECONDARY VIDEO
0
CHANGE SECONDARY VIDEO
0
SECONDARY AUDIO
0
SECONDARY AUDIO LANGUAGE
SUBTITLE LANGUAGE
SUBTITLE STYLE
CHANGE ANGLE
Playback settings
.
2.#;$#%-5'66+0)
4'2'#6
1((
%*#0)'6+6.'
%*#0)'%*#26'4
6+/',7/2
REPEAT
The following items can be set.
Items are not displayed if they cannot be set.
Setting Values
Description
OFF
Turns off repeat.
TITLE
Repeats playback of the currently played
title.
CHAPTER
Repeats playback of the currently played
chapter.
TRACK
Repeats playback of the currently played
track.
FOLDER
Repeats playback within the currently
played folder.
ALL
Repeats playback of the entire disc.
A-B
Repeats playback of the section between the
specified starting and ending points.
Pressing the [OK] button specifies the displayed
scene as the starting point (Point A). Pressing the
[OK] button after forwarding playback specifies
the displayed scene as the ending point (Point
B).
CHANGE TITLE
You can change to a different title by entering the corresponding
numeric value. Any value that is larger than the number of titles
cannot be entered.
CHANGE CHAPTER
You can change to a different chapter by entering the corresponding
numeric value. Any value that is larger than the number of chapters
cannot be entered.
TIME JUMP
You can move to a specific playback position by entering a time.
This is not possible if the specified time is not valid.
SLIDESHOW INTERVAL
The following items can be set.
3SEC/5SEC/10SEC/20SEC/30SEC modes
SLIDESHOW EFFECTS
The following items can be set.
Setting Values
Description
OFF
Turns off slideshow effect.
ON
Turns on slideshow effect. “Fade out” and
“Fade in” effects can be applied when
switching from one slide to another.
66
Changing Playback Settings
Pl
aying
Ba
ck