62
EN
OTHER PROBLEMS
CORRECTIVE ACTION
If you need the skipped channels,
restore them (
墌
pg. 14).
Press
PAUSE
to pause the recording,
change channels, then press
PLAY
to
resume recording.
Re-set the remote control to the
correct brand (
墌
pg. 56 or 57 or 58).
Select a different Host Channel during
the Semi-Auto setting procedure
(
墌
pg. 11), or perform the Manual
setting procedure (
墌
pg. 12).
Press and hold
OK
on the remote
control for more than 5 seconds to
deactivate Mode Lock.
SYMPTOM
1. When scanning channels, some of
them are skipped over.
2. The channel can’t be changed.
3. The remote control won’t operate
my TV or cable box or DBS receiver.
4. Even though Auto or Semi-Auto
clock setting has been selected, the
clock is incorrect.
5. Buttons and controls do not
function at all.
POSSIBLE CAUSE
●
Those channels have been preset to
be skipped.
●
Recording is in progress.
●
The remote control brand setting is
incorrect.
●
The clock setting data received from
the Host Channel is incorrect.
●
Mode Lock is activated.
ATTENTION
This VCR contains microcomputers. External electronic noise or interference can cause microcomputer to malfunction. If the VCR
does not operate correctly switch its power off and unplug the power cord from the AC supply. Wait for a while and then plug the
power back in. Eject and check the condition of the cassette. If everything appears normal resume operating the VCR as usual.
TROUBLESHOOTING (cont.)
