Filename [SR-V10E1a-EN.fm]
Masterpage:Left
18
EN
Page 18
September 3, 2002 10:20 am
PLAYBACK (cont.)
Next Function Memory
The Next Function Memory “tells” the recorder what to do after
rewinding. Before continuing, make sure the recorder is in the
Stop mode.
a-
For Automatic Start Of Playback
Press
3
, then press
4
within 2 seconds.
b-
For Automatic Power Off
Press
3
, then press
1
within 2 seconds.
c-
For Automatic Timer Standby
Press
3
, then press
#
(
TIMER
) within 2 seconds.
NOTE:
The Automatic Power Off does not work if “AUTO TIMER” is set
to “ON” (
墌
pg. 45) and if any timer programming has been
made. The recorder directly goes into the Timer-Standby mode
after rewinding a tape.
Repeat Playback
Your recorder can automatically play back the whole tape
repeatedly.
1
Start playback.
Press
4
.
2
Activate Repeat Playback.
Press
4
and hold for over 5 seconds, then release.
●
The Play indicator (
$
) on the front display panel blinks slowly.
3
Stop Repeat Playback.
Press
8
at any time.
●
Pressing
4
,
3
,
5
or
9
also stops Repeat Playback.
NOTES:
●
Repeat playback is not possible with a cassette recorded in EP
mode.
●
To select the returning point (recording end or tape end), see
“RETURN POINT” (
墌
pg. 48).
●
It is possible to use the Mode Lock function. (
墌
pg. 17)
Manual Tracking
Your recorder is equipped with automatic tracking control.
During playback, you can override this and adjust the tracking
manually by pressing the
PR
buttons.
1
Override automatic tracking.
During playback, press
p
on the remote control.
2
Adjust the tracking manually.
Press
PR
+
or
–
on the remote control.
●
Press
p
again to return to automatic tracking.
NOTE:
When a new tape is inserted, the recorder enters the automatic
tracking mode automatically.
Soundtrack Selection
Your recorder is capable of recording three soundtracks (HI-FI L,
HI-FI R and NORM) and will play back the one you select.
During Playback
Pressing
AUDIO
changes the soundtrack as follows:
NOTES:
●
“HI FI L
j
h
R” should normally be selected. In this mode,
Hi-Fi stereo tapes are played back in stereo, and the normal
audio track is played back automatically for tapes with only
normal audio.
●
For instructions on recording stereo and bilingual
programmes, refer to page 22.
●
“O.S.D. (PLAY)” must be set to “ON”, or the on-screen
displays will not appear (
墌
pg. 46).
TRACK
USE
On-Screen Display
HI FI
L
j
h
R
For Hi-Fi stereo tapes
HI FI
L
j
For main audio of Bilingual tapes
HI FI
h
R
For sub audio of Bilingual tapes
NORM
For audio-dubbed tapes
HI FI
NORM
For audio-dubbed tapes
SR-V10E1a-EN.fm Page 18 Tuesday, September 3, 2002 10:21 AM