Masterpage:Right-Full-NoTitle0
EN
47
Filename [SR-V10E4-EN.fm]
Page 47
August 8, 2002 5:41 pm
* The default setting is
bold
in the table below.
8
DIGITAL 3R
ON
OFF
When this function is set to “ON”, the Digital 3R picture system applies edge
correction to the luminance signal to enhance detail.
NOTES:
●
Normally it is recommended to keep “DIGITAL 3R” set to “ON”.
●
Depending on the type of tape being used, picture quality may be better with “DIGITAL 3R” set
to “OFF”.
●
If you use the recorder as the source player for editing, be sure to set “DIGITAL 3R” to “OFF”
before starting.
8
POWER SAVE
ON
OFF
When this function is set to “ON”, you can reduce the power consumption while the
recorder is turned off.
NOTES:
●
During Power Save mode ...
... the front display panel will be turned off.
... the Just Clock function (
墌
pg. 56) does not work.
... the picture may be distorted momentarily when you turn on/off the recorder.
●
Power Save does not work when ...
... the recorder is in the Timer mode.
... the recorder’s power is turned off after timer-recording.
... the Automatic Satellite Programme Recording mode is engaged (
墌
pg. 35).
8
VIDEO STABILIZER
ON
OFF
When this function is set to “ON”, you can automatically correct vertical vibration in
the picture when playing back unstable recordings made on another recorder.
NOTES:
●
When you finish viewing a tape, be sure to set this function to “OFF”.
●
Regardless of the setting, this function has no effect during recording and during special effects
playback.
●
The on-screen display may jitter vertically when this function is set to “ON”.
●
To watch recordings with close-caption, set this function to “OFF”.
●
Video Stabilizer and Digital TBC/NR cannot be used at the same time. If you activate Digital
TBC/NR when “VIDEO STABILIZER” is set to “ON”, Video Stabilizer will be automatically
turned “OFF”.
8
S-VHS
ON
OFF
Your recorder can record in S-VHS (Super VHS), S-VHS ET or VHS.
●
To record in S-VHS:
Set “S-VHS” to “ON”. Then, insert a cassette marked “S-VHS”. The S-VHS indicator
lights up on the front display panel.
The S-VHS recording mode is selected.
●
To record in S-VHS ET on a VHS cassette:
See “Super VHS ET (S-VHS ET)” on page 22.
●
To record in VHS:
Insert a cassette marked “VHS”.
Press
S-VHS ET
on the recorder. You can check the current setting (“S-VHS ET : ON” or
“S-VHS ET : OFF”). If “S-VHS ET : ON” appears on the TV screen, press
S-VHS ET
again in about 5 seconds to set it to “OFF”.
The VHS recording mode is automatically selected regardless of the “S-VHS” mode
setting.
●
To record in VHS on an S-VHS cassette:
Insert a cassette marked “S-VHS”. The S-VHS indicator lights up on the front display
panel. Then, set “S-VHS” to “OFF”. The S-VHS indicator goes off.
The VHS recording mode is selected.
NOTE:
When playing back a tape that has been recorded in S-VHS or S-VHS ET, the S-VHS indicator
lights up on the front display panel regardless of the “S-VHS” mode setting.
SR-V10E1-EN.book Page 47 Monday, August 19, 2002 10:20 AM
