14
NOTE
• Manufacturers’ codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.
7
To set the manufacturer’s code
1
Slide the remote control mode selector
to TV.
2
Press and hold
F
TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
4
Press number buttons (1-9, 0) to enter
the manufacturer’s code (2 digits).
Examples:
For a Hitachi TV: Press
1
, then
0
.
For a Toshiba TV: Press
0
, then
8
.
*
“01” is the initial setting.
5
Release
F
TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
7
Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to
TV
.
The following buttons are available:
F
TV
:
Turns TV on and off.
TV VOL +/–
:
Adjusts the volume.
TV/VIDEO
:
Selects the input mode (either TV or
VIDEO).
CH +/–
:
Changes the channels.
1-10, 0,
h
10 (100+)
: Selects the channel.
TV RETURN
:
Alternates between the previously selected
channel and the current channel.
NOTE
• The operating buttons may differ depending on manufacturers.
The buttons described below are used on pages 14 and 15.
Remote
control mode
selector
Number
buttons
(play button)
Operating the TV
Manufacturer
Code
Manufacturer
Code
JVC
01
*
Samsung
12
Hitachi
10
Sanyo
13, 14
Magnavox
02
Sharp
06
Mitsubishi
03
Sony
07
Panasonic
04, 11
Toshiba
08
Philips
15
Zenith
09
RCA
05
Operating external components with the remote control
EN_TH-C43[C]3.book Page 14 Tuesday, March 14, 2006 4:44 PM