21
FM Radio Operation
• Make sure that you have correctly connected and fully extended the antenna.
• The search may not stop at a station with a very weak signal.
• If reception is still poor, try to adjust the DAB / FM aerial location.
Press the SOURCE button on the unit or press the FM button on the remote control to
select FM mode.
Tuning in a Station
Auto Tuning
Press and hold / button on the remote control, the frequency changes down or up
automatically until a station is found.
The search may not stop at a station with a very weak signal.
Manual Tuning
Press the / button repeatedly to change the frequency until you find the station you
want.
• With FM radio it may be necessary to fine tune each station by pressing
/
repeatedly. Each press
will adjust the frequency by 0.05MHz. If reception is still poor adjust the position of the aerial or try
moving the radio to another location.
• You may press and hold FM button to switch between STRONG and WEAK for station tuning.
• You may press and hold
/ CLEAR button to clear the previously tuned stations before running an
auto scan. The display will show CLEAR. All the tuned stations in both DAB and FM will be cleared.
Presetting Stations
You can store up to 20 of your favourite stations to the memory. This will enable you to
access your favourite stations quickly and easily.
Automatically
Press the INTRO/SCAN button on the remote control to activate automatic tuning. The unit
will automatically search and store the first 20 radio stations it finds.
The first programmed radio station will play automatically.
Manually
1. Tune into a desired radio station as shown above.
2. Press the PROG button on the remote to activate program mode. The preset number
will flash in the display.
3. Press ALBUM/PRESET / to select the programme position number (1-20).
4. Press PROG again to store the station.
Preset Tuning
After the stations are preset (for details, please refer to the section “Presetting Stations”
below), repeatedly press the ALBUM/PRESET / buttons on the remote control to select
the desired preset number. Its band and frequency are displayed on the front panel. Press
ENTER to confirm.
UX-D427S_IB_FInal180625V3.indd 21
26/6/2018 5:30 PM
