1-16 (No.MB542)
3.2.5 Removing the pickup
(See Fig.7 to 9)
• Remove the traverse mechanism assembly.
(1) Remove the one screw
E
attaching the plate from upper
side of traverse mechanism assembly. (See Fig.7)
(2) Remove the plate from fixing part
k
then take out the plate.
(See Fig.7)
(3) Remove the two screws
F
attaching the LEAD spring and
then take out the LEAD spring. (See Fig.8)
(4) Take out the feed gear, and then remove the shaft of pick-
up from part
m
of the traverse mechanism assembly. (See
Fig.8)
(5) Remove the pickup from part
n
of the traverse mechanism
assembly and then take out pickup with shaft. (See Fig.8)
(6) Release the shaft from pickup. (See Fig.8)
(7) Solder the short land part
p
of the pickup. (See Fig.9)
(8) Release the lock of the connector to direction of the arrow,
and then disconnect the card wire. (See Fig9)
Caution:
• Solder to short land part
p
of the pickup then disconnect the
card wire from connector. If disconnect the card wire before
soldering, pickup is make sure destroyed by static electricity.
(See Fig.9)
• When reattaching the pickup, connect the card wire to con-
nector and then remove the solder from short land part
p
.
(See Fig.9)
3.2.6 Attaching the pickup
(See Fig.7 to 10)
• Please refer the "Removing the pickup".
(1) Connect the card wire to connector of pickup, and then re-
move the solder from short land part
p
of the pickup. (See
Fig.9)
(2) Attach the shaft to pickup. (See Fig.8)
(3) Fit the pickup to part
n
of the traverse mechanism and then
attach the end of the shaft to part
k
. (See Fig.8)
(4) Attach the LEAD spring and feed gear. (See Fig.8)
(5) Attach the plate. (See Fig. 7)
(6) One turn the LEAD gear to direction of the arrow 1 and fully
shift to direction of the arrow 2. (See Fig.10)
Fig.7
Fig.8
Fig.9
Fig.10
Plate
E
Fixing part
k
Traverse mechanism assembly
F
Part
m
Part
m
Pickup
Feed gear
Shaft
LEAD spring
Pickup
Connector
Card wire
Short land part
p
Traverse mechanism assembly
LEAD gear
Pickup
1
2
Summary of Contents for UX-GB9DABB
Page 35: ... M E M O ...
