(No.MB422)1-11
3.2.5 Removing the Rear Panel the Tuner and the Speaker Board
(See Fig.5-1, Fig.5-2 and Fig.5-3)
(1) Unscrew the 15 screws
C
from the Main Board unit, the
Tuner, the Heat Sink, the Chassis Main and the scart
Board unit.
(2) Pulling out the 2 cable connectors from the AMP Board unit
and the Power Board unit then removing the Panel Rear,
the Tuner and the Speaker Board.
Fig.5-1
Fig.5-2
Fig.5-3
C
C
CONNECTOR
CONNECTOR
Summary of Contents for UX-GD7
