UX-M3R
1-11
Fig.23
Fig.24
Fig.25
V
V
CD & MCU board
Stud
Stud
CD & MCU board
CD mechanism assembly
CD pickup assembly
Damper(Blue)
CD pickup unit
W
CN704
W
Damper(Gray)
Damper(Blue)
Damper(Gray)
CD pickup
assembly
Short land part
n
CN703
CN702
Removing the CD & MCU board
(See Figs. 23 and 24.)
1.
2.
3.
4.
5.
From the back side of the CD mechanism
assembly, remove the four screws
V
retaining the
CD & MCU board.
Disengage the two studs retaining the CD & MCU
board.
Disconnect the wires from the two connectors
CN702 and CN703 on the CD & MCU board.
Lift the CD & MCU board and attach solder to the
short land part
n
on the CD pickup assembly.
Disconnect the card wire from the connector
CN704 on the CD & MCU board, and take out the
CD & MCU board.
[Caution] Be sure to solder the short land
part n on the CD pickup unit before
disconnecting the card wire from the
CD pickup assembly (see Fig. 24).
If the card wire is disconnected
without attaching solder, the CD
pickup may be destroyed by static
electricity.
In the assembly, be sure to remove
solder from the short land part n
after connecting the card wire.
Remove the left and right side panels.
Remove the top cover.
Remove the front panel assembly.
Remove the CD mechanism assembly.
<CD mechanism section>
Removing the CD pickup assembly
(See Fig. 25.)
1.
2.
Remove the CD & MCU board.
From the back side of the CD mechanism
assembly, remove the four screws
W
retaining the
CD pickup assembly.
Take out the CD pickup assembly.
[Note] When removing or replacing the
dampers, note their colors and be sure
to attach them in their correct positions.
