JVC UX-M5, Instruction Manual

– 10 –

English

Listening to FM and AM Broadcasts

TUNER

BAND

TUNER

BAND

SEARCH/TUNING

ST/MONO

REPEAT

PROGRAM

DIRECTION

PLAY/PAUSE

PRESET

TUNER

BAND

DIRECTION

PLAY/PAUSE

PRESET

Presetting Stations

You can preset 20 FM and 20 AM stations.

• There is a time limit in doing the following steps. If the

setting is canceled before you finish, start from step 1
again.

1 Tune in the station you want to preset.

• See “Tuning In a Station” on the left.

2 Press PROGRAM.

The PROGRAM indicator and “00”
start blinking on the display.

3 Press PRESET 

∞

 or 

5

 (or

PRE DOWN 

8

/

2

 or PRE

UP 

3

/

8

 on the remote

control) to specify the
desired preset number.

4 To preset more stations, repeat steps 1 to 3

above, allocating a different preset number to
each station.

notes

When a new station is stored

The station previously memorized with the same preset
number is erased. (The frequency of the new station replaces
the previous frequency in memory.)

Tuning In a Preset Station

1 Press TUNER/BAND to

select tuner mode.

2 Press TUNER/BAND to select the band, FM

or AM.

3 Press PRESET 

∞

 or 

5

 (or

PRE DOWN 

8

/

2

 or PRE

UP 

3

/

8

 on the remote

control) to select the desired
preset number.

Tuning In a Station

1 When the unit is turned on,

press TUNER/BAND to
select tuner mode.

The unit tunes in the last station
tuned in (either FM or AM).

2 Press TUNER/BAND to

select the band, FM or AM.

Each time you press the button, the
band selection alternates between
FM and AM.

3 Press and hold 

4

 or 

¢

for more than 1 second.

The unit starts searching for stations
and stops when a station of sufficient
signal strength is tuned in.
If a program is broadcast in stereo,
the STEREO indicator lights up.

To stop searching, press 

4

 or 

¢

.

notes

When you press 

4

 or 

¢

 briefly and repeatedly

The frequency changes step by step.

To improve the FM reception

When an FM stereo broadcast is hard to
receive or noisy, press REPEAT ST/
MONO to switch to the monaural
reception. The STEREO indicator
disappears from the display.

To restore the stereo reception, press REPEAT ST/MONO
again so that the STEREO indicator lights up.

To change FM/AM tuning interval

The unit’s default tuning interval is 100 kHz/step for FM
reception and 10 kHz/step for AM. You can change this
setting to 50 kHz/step for FM and/or 9 kHz/step for AM
when using the unit in an area of different frequency
allocation system.

1 Press TUNER/BAND to select “FM” or “AM”.

2 While holding down STOP/CLEAR 

7

 on the unit, press

repeatedly to select the desired tuning
interval.

02_01_19_UXM5_UW_En.p65

5/17/02, 5:23 PM

10