15
Warning
To prevent the camera from falling off, ensure that it is connected to
a firm place (ceiling slab or channel) using a Safety Wire (Fall
Prevention Wire is not supplied).
Pay also careful attention to the length, strength, wiring, and
material (insulating properties) of the fall prevention wire to be used.
The length should be as short as possible within the permissible
range of the mounting length. The wire should be strong enough to
withstand the total weight of this product. (Pay also attention to the
finishing at the end of the wire.) The thickness of the wire
’s end of
camera side should be less than 1mm.
Caution
Must be isolated camera and the wall/ceiling which are connected
by the Safety Wire (Fall Prevention Wire).
4S Electrical junction box (Optional)
1.
Secure the mounting kit (optional) to 4S Electrical box using 2
appropriate screws.
2.
Then secure the camera case to mounting kit using 2 appropriate
screws.
3.
Tuck the cables in the 4S Electrical box.
4.
Adjust the view angle (zoom, focus, and Horizontal Rotation).
5.
Attach the camera housing.
6.
Turn the power on after you have installed the camera.
Safety Wire
(Fall Prevention Wire, not supplied)
