50
Daylight
Figure 4-42 Daylight
Daylight Saving
Select
“ON” to activate the daylight-saving function if you are in a daylight
saving time zone (effective for NTP mode only), and then choose the starting
time ,ending time and time adjustment.
Note
Please click the “Save” button to save your settings. You can also
click the left button “Reset to Default” to set all the data and
options as defaults.
Update
You can update system firmware if the update file is available. It is the
customer's responsibility to update firmware. All camera motions will shut down
during firmware update. Close any other screens before starting a firmware
update. Never disconnect power and LAN cable during the firmware update
process. Rebooting the camera after firmware update may take approx. 15
minutes. After you finish FW update, please reboot your computer first time. Be
careful, power can’t be shut down when you’re updating firmware. Otherwise, it
will cause FW update failure and you have to call back to maintenance.
Figure 4-43 Firmware Update
Configuration
Video Type
Users can select “NTSC” or “PAL” according requirement.
Flicker by fluorescent light can be reduced by selecting PAL mode if the public
power is 50Hz or NTSC mode if the power is 60Hz.
