28
Englis
h
Troubleshooting
• If you are having a problem with your System, check this
list for a possible solution before calling for service.
• If you cannot solve the problem from the hints given
here, or the System has been physically damaged, call a
qualified person, such as your dealer, for service.
Symptom
Possible Cause
Action
No sound is heard.
• Connections are incorrect, or loose.
• Headphones are connected.
• Check all connections and make
corrections. (See pages 4 to 8.)
• Disconnect the headphones.
Poor radio reception
• The antenna is disconnected.
• The AM Loop Antenna is too close to the
System.
• The FM Wire Antenna is not properly
extended and positioned.
• Reconnect the antenna securely.
• Change the position and direction of the
AM Loop Antenna.
• Extend FM Wire Antenna to the best
reception position.
The CD skips.
The CD is dirty or scratched.
Clean or replace the CD.
The CD does not play.
The CD is upside down.
Put the CD in with the label side up.
Unable to operate the Remote Control.
• The path between the Remote Control
and the sensor on the Unit is blocked.
• The batteries have lost their charge.
• Remove the obstruction.
• Replace the batteries.
Operations are disabled.
The built-in microprocessor has
malfunctioned due to external electrical
interference.
Unplug the System then plug it back in.
“CD NO DISC” appears.
There is no disc loaded.
Insert a disc.
“CANNOT PLAY” or “UNFINALIZ”
appears.
• The CD-R or CD-RW that hasn’t yet been
finalized (including blank discs) has been
inserted.
• The disc has been inserted with its label
side down.
• Insert a CD-R or CD-RW that has been
finalized.
• Remove the disc and insert it with the
label side front or up. (See page 19.)
The characters and symbols on the display
appear upside down.
The DISP.SET switch on the rear panel of
the Center Unit has not been set correctly.
Set the DISP.SET switch correctly. (See
page 11.)
Subwoofer automatically turns on, but no
sound is output.
The volume knob of the Subwoofer is set to
MIN position.
Adjust the volume knob.
Subwoofer does not automatically turn on.
The volume knob of the Subwoofer is set to
MIN position. Also, the volume level of the
Center Unit is low.
Adjust both volume levels.
VS-DT2000[US-UW]_EN.book Page 28 Friday, March 8, 2002 3:09 PM
