3
XL-MC334BK
LVT0022-001B [J]
Installing batteries in the remote
control
The battery compartment is located on the back of the remote
control.
1. Press down on the triangular
mark of the compartment
cover, and pull up the cover
to open the compartment.
2. Set the two supplied batteries
R6P (SUM-3)/AA(15F) in
the compartment with the
correct polarities.
3. Place the cover over the
compartment, and press
down.
CAUTION
• Install the batteries with their polarities correctly set.
• Remove the batteries if the remote control is not
going to be used for an extended period of time.
• Do not expose the remote control to heat, flame, or
direct sunlight.
Replacing the batteries
The service life of batteries normally lasts for about one year though
it depends on the use of the remote control (and is shorter at low
temperatures, too). Replace the batteries any time if the controllable
range is reduced (max. range: 7 meters or 23 feet and 30 degrees
away from the unit).
CAUTION
• Be sure to replace them with the correct batteries
(R6P(SUM-3)/AA(15F)).
• Do not use a combination of new and old batteries.
3. TEXT COMPU LINK connection
If you are using a JVC audio amplifier/receiver supporting
TEXT COMPU LINK, connect either one of the TEXT COMPU
LINK ports on the back of the unit with the amplifier/receiver’s
TEXT COMPU LINK port using the supplied TEXT COMPU
LINK cord (green).
OUTPUT
COMPULINK-3
(SYNCHRO)
RIGHT
LEFT
TEXT
COMPULINK
DIGITAL
(OPTICAL)
To TEXT
COMPU LINK jack
TEXT COMPU LINK
cord (Green)
By using the TEXT COMPU LINK system, you can see the
disc information or search result on the TV monitor, as well as
copy disc information to a MD, and more.
(See “TEXT COMPU LINK SYSTEM” on page 21.)
4. Power connection
Connect the supplied AC power cord into the socket on the
back of the unit. Then insert the AC plug into an AC outlet.
(If you use the COMPU LINK system, do not connect the AC
plug into a switched AC outlet of a component.)
AC POWER CORD
AC outlet
AC power cord
