Page 6
JVC’s COMPU LINK Remote Control System provides unified control
over system components connected with COMPU LINK. Connecting
JVC audio components with the COMPU LINK jacks automatically
controls relative operations between components and facilitates vari-
ous operations. With the COMPU LINK connection to an amplifier or
receiver, you can operate XL-V130BK/XL-V230BK with the amplifier or
receiver’s remote control unit. Synchronized recording is also avail-
able with this feature.
Connecting the COMPU LINK cord
The COMPU LINK-3 SYNCHRO jacks are used to output and input the
control signal for the COMPU LINK remote control system.
COMPU LINK-compatible products are provided with the jacks marked
COMPU LINK-1, COMPU LINK-2 or COMPU LINK-3, referring to the
COMPU LINK version. XL-V130BK/XL-V230BK is equipped with
COMPU LINK-3. You can connect XL-V130BK/XL-V230BK also to a
component with a lower COMPU LINK versions. But, in that case, only
the lower versions’ features will be available.
Plug the supplied COMPU LINK cord into the COMPU LINK-3 SYNCHRO
jack on the rear panel of XL-V130BK/XL-V230BK. Plug the other end
into the COMPU LINK jack of the other component. If there are two
COMPU LINK jacks, plug it into either of them.
Connecting the COMPU LINK system components with the COMPU
LINK cords
Cassette deck
Turntable
Supplied COMPU LINK cord
CD player
Amplifier or receiver
To install the batteries in the remote
control unit
Before operating the remote control unit, install two batteries.
1.
Remove the rear cover of the remote control unit by pressing
down and simultaneously pulling it backwards.
2.
Install batteries. Be sure that the batteries are installed with
correct polarity, (+) and (–).
3.
Attach the rear cover by sliding it back into position.
BEFORE USING FOR THE FIRST TIME
Notes
Incorrect use of batteries can cause corrosion or damage. Note the
following points to lengthen battery life.
÷
Install batteries observing the correct polarity, (+) and (–).
÷
Do not use new and old batteries simultaneously.
÷
Batteries with similar shapes may have different voltage ratings. Be
sure to use the correct batteries.
÷
Remove batteries from the remote control unit if it will not be used
for a long period of time.
÷
Do not expose batteries to heat or flame.
Battery replacement
Service life of batteries depends on the condition of use; standard life
is about one year. When the batteries become weak, the operating
distance of the remote control unit becomes short . If this happens,
replace the batteries R03(UM-4)/AAA(24F) with new ones.
Note
÷
The lower the temperature, the shorter the battery life.
COMPU LINK connection
Installing the batteries
(XL-V230BK Only)
XL-V130BK [BS] EN
97.3.7, 4:11 PM
6
