PORTABLE DVD PLAYER V12M12_IM_EN_04232008
- 11 - www.jWIN.com
GETTING STARTED
REMOTE CONTROL BATTERY INSTALLATION
Before starting to operate the remote control, please pull out the
insulation plate from the battery compartment.
1. Pull out the battery holder as shown right.
2. Place one battery (CR 2025) as shown right. Make sure that
the polarity (+/–) of battery matches the marks inside the
unit.
3. Insert the battery holder into its compartment as shown right.
Note:
Do not attempt to recharge, short-circuit, disassembly,
heat or throw the batteries into the fire.
RECHARGEABLE BATTERY INSTALLATION
The rechargeable battery pack is included in the package as separately packed.
1. Loading the rechargeable battery
•
Unpack the rechargeable battery.
•
Insert it into the slot at the back of the main unit as
shown left. If properly inserted, you will hear the
“CLICK!” sound.
Note
: For the first time use, please charge the battery
fully first before use. It will take approximately 3 hours
to fully charge it.
2. Loading the rechargeable battery
•
Push and hold the lock button down at the back of
the main unit as shown right.
•
Push the installed battery back to release.
USING THE AC ADAPTER
1. Insert the DC plug at the end of the adapter cord
into the DC ‘IN’ jack at the right side of the player.
2. Plug the other end into an AC wall outlet.
Notes:
•
Only use with the supplied AC adapter. Using with
another AC adapter could cause damage.
•
Remove both the DC plug and AC plug to
disconnect the AC adapter when not necessary.