You should also check that the vermiculite plates are correctly fitted inside the combustion chamber. The position of
these is shown in the illustration in this instruction manual.
You must install your stove according to the required minimum distance to combustible materials. See also the boiler
plate on the stove for details.
In addition, it is important to check that the Vermiculite panels are correctly fitted in the combustion chamber.
Floor/foundation/wall
The stove must be installed / hanged on a non-combustible foundation / at a non-combustible wall - i.e. where a tile or
brick floor is non-existing, the stove must meet the demands for the distance to combustible material under / above /
beside the stove, according to applicable legislative requirements. Consult you dealer before installing the stove.
3. Warranty
Brand new wood burning stoves from Jydepejsen A/S come with a 5 year warranty. The warranty includes defects and
burn through with correct operation.
Any claims during the warranty period should be directed to the dealer who sold the stove. All stoves from Jydepejsen
come with their own individual serial number on the type plate on the back of the stove. Please quote stove model and
serial number to your dealer in connection with service tasks.
In the event of warranty repairs, a signed and dated invoice must also be produced, showing the dealer’s name. The
warranty does not cover dismantling, transport and reassembly of your stove.
No compensation will be granted for
- Damage during transport.
- Damage to other articles resulting from use of the stove.
- Damage arising from misoperation or incorrect usage, such as overheating – avoid this by reading the operating
instructions carefully.
- The directions in the operating instructions have not been followed.
The stove is supplied with wearing parts, which are to be replaced due to usage of the stove. These parts are not covered
by the warranty – how often they are to be replaced is individual and depends on the stove usage. The wearing parts are:
Vermiculite panels - baffle plates - sealing band.
Furthermore, Glass and soapstone are not covered by the warranty. If any of the above mentioned need replacing, new
parts can be ordered from your dealer.
4. Stoking instructions
It is very important to ensure that your chimney has a decent draught. The Alpha and Omega is the cooperation
between the chimney and the stove. Your dealer or your chimney sweep will be able to guide and advice you on your
chimney conditions.
When this is settled, the next step is that you make the stove and the chimney cooperate. This is done by following the
operating instructions and using fuel which inflames easily in the combustion chamber, until a decent draught is obtained.
For further information on correct lighting and stoking, please refer to Jydepejsen´s Manual for installation and stoking.
Please note that the stove paint will harden during the first few initial lightings. This means that the stove will generate
smoke and an odour of paint, which will dissipate after about 1 hours´s operation. It is a good idea to ensure effective
[GB 3,4]
