PCIe/PXIe-5211 |
| 59
3. Route trigger signals of all tasks to the same signal terminal, trigger signal will be
sent from the master card to all slave cards through this terminal.
4. Route Sync Pulse signals of all tasks to the same signal terminal, Sync Pulse
signals will be sent from the master card to all slave cards through this terminal.
5. Start all slave tasks.
6. Start the master task (if digital trigger or software trigger is enabled, you need to
wait for the trigger signal to arrive), all the tasks will start to work synchronously
on a rising edge of the PXIe_SYNC100 signal.
4.9 System Synchronization Interface (SSI)for PCIe Modules
The synchronization between PCIe modules are handled differently from the PXIe
synchronization, it is implemented by the system synchronization interface (SSI). SSI
is designed as a bidirectional bus and it can synchronize up to four PCIe modules.
One PCIe module is designated as the master module and the other PCIe modules
are designated as the slave modules.
Figure 54 SSI Connector in PCIe-5211
Table 7 SSI Connector Pin Assignment for PCIe-5211
Summary of Contents for PCIe-5211
