21
rev.A
KN6 - KN10S
12. KN10 TECHNICAL DETAILS
KN10S
Acoustics
Power handling
2 x 250 w
(AES)
Maximum amplifier power
2 x 500 w
(EIAJ)
Impedance
2 x 4 Ω
Operating frequency range
30Hz - 150 Hz +/- 3dB (preset dependent)
Frequency range
40Hz - 150 Hz +/- 3dB (preset dependent)
SPL 1W/1mt
95 dB
Maximum SPL
124dB continuous - 130 dB peak
Coverage
Horizontal
Omni
Vertical
Omni
Crossover
Type
DSP controlled
Frequency
150 Hz minimum (preset dependent)
Transducers
Low - Mid frequency
2 x 10” Neodymium speakers with 2” voice coil
Audio Input
Connectors
male + female parallel 3-pin balanced XLR
Wiring
PIN1= ground PIN2 = hot PIN3 = cold
Power Input
Connector
1 x PowerCon
Amplifiers
Type
1 module class D - DSP controlled
Power (woofer)
350 + 350 Watt
1
Protection
Dynamic limiter, over current, over temp, short circuits
AC power
Operating range
85 - 270 Vac 50/60Hz autorange
Max continuous
and burst current
140VA(>10 sec) - 700VA (<1 sec) autorange
Physical
Dimensions
50.5 x 33.5 x 28 cm (19.88”x 13.19”x 11.02”)
Weight
17 Kg (37.48 lbs)
Notes for data
1. Amplifier wattage rating is based on the maximum unclipped burst sine wave RMS voltage that the
amplifier will produce into the nominal load impedance .
New materials and design are introduced into existing products without previous notice. Present
systems may differ in some respects from those presented in this brochure.
Summary of Contents for KN6
