Kommander-KA02 I
User Guide
4
FCC Statement
Canadian Statement
Trademark Notice
FCC Radiation Exposure Statement
CE Statement
•
Before turning the power on or off for all devices, set all volume levels to
minimum.
•
Use only speaker cables for connecting speakers to the speaker terminals.
Be sure to observe the amplifier’s rated load impedance particularly when
connecting speakers in parallel. Connecting an impedance load outside the
amplifier’s rated range can damage the apparatus.
•
K-array cannot be held responsible for damage caused by improper use of the
loudspeakers.
•
K-array will not shoulder any responsibilities for products modified without prior
authorization.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment must be installed and operated in accordance with
provided instructions and the antenna(s) used for this transmitter must be installed
to provide a separation distance of at least 20 cm from all persons.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that
may cause undesired operation.
CAUTION!
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
K-array declares that this device is in compliance with applicable CE
standards and regulations. Before putting the device into operation,
please observe the respective country-specific regulations!
This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions:
•
this device may not cause interference, and
•
this device must accept any interference, including interference that may cause
undesired operation of the device.
The device meets the exemption from the routine evaluation limits in section 2.5
of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian
information on RF exposure and compliance.
This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
All trademarks are the property of their respective owners.
