KNX/EIB
Switch Actuator with Secure
30
4.4.3. Parameter window “X: Logic”
It will show up Fig. 4.4.3 when “Function of ‘logic’ for switch” is enabled in Fig. 4.4(2).
Fig. 4.4.3 Parameter window “X: Logic”
There are 2 logic communication objects to decide the status of individual output, which are
related to the “Switch”.
It will re-operate when receiving a new object value as the final output status (close the contact
with “1”, open it with “0”).
The value of the communication object “Input 1 of logic” is logically operated with “Switch,X”
firstly,and then the result is logically operated with the value of “Input 2 of logic”.This operation will
ignore the object which are disable,and continue to the next step with the enabled objects.
Parameter “The input 0 (switch object) for logic is”
This parameter is used to enable the function of logic operation of “Input 0”, whose values are
wrote by the object “Switch”.
Parameter “The input x of Logical” (x = 1, 2)”
This parameter describes the status of the logic operation of the object “Input 1 of logic” or “Input
2 of logic”.
